Acer K192HQL driver and firmware
Related Acer K192HQL Manual Pages
Download the free PDF manual for Acer K192HQL and other Acer manuals at ManualOwl.com
User Manual - Page 4
...power from the equipment, be sure to unplug the power cord from the electrical outlet.
Safe listening
To protect your hearing, follow these instructions.
• Gradually increase the volume until you can hear it clearly and comfortably
and without distortion.
• After setting...in installation unless ...devices.
Using electrical power
• This product should be operated from the type of power...
User Manual - Page 9
...reflections by: • placing your display in such a way that the side faces the window or
any light source
• ...display's top front edge
• Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended
periods of time.
Developing good work habits
Develop the following work habits to make your computer...
User Manual - Page 12
... Federal Communications Commission Declaration of Conformity Unpacking Attaching/removing the base Screen position adjustment Connecting the power cord Power saving Display Data Channel (DDC) Connector pin assignment Standard timing table Installation User controls How to adjust a setting Acer eColor Management Troubleshooting VGA mode
1
iii iii iii iii iii iv iv iv iv v vi vi vii vii viii
xi...
User Manual - Page 15
...-colored power LED.
Mode On
Power saving
LED light Blue
Amber
The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the...
User Manual - Page 18
...
6
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable a Make sure both the monitor and computer are switched off. b Connect the VGA video cable to the computer.
2 Connect the power cord Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Turn on the monitor and computer...