Asus CUA driver and firmware
Related Asus CUA Manual Pages
Download the free PDF manual for Asus CUA and other Asus manuals at ManualOwl.com
CUA User Manual - Page 2
... are released for each product design represented by the digit before and after the period of the manual revision number. Manual updates are represented by the third digit in the manual revision number.
For previous or updated manuals, BIOS, drivers, or product release information, contact ASUS at http://www.asus.com.tw or through any of the means indicated on the following...
CUA User Manual - Page 10
... compliant Audio Codec with 3D sound circuitry and sample rate conversion from 7kHz to 48kHz.
2.1.3 Performance
• Concurrent PCI: Concurrent PCI allows multiple PCI transfers from PCI master busses to the memory and processor.
• High-Speed Data Transfer Interface: IDE transfers using UltraDMA/33 Bus Master IDE can handle rates up to 33MB/s. This motherboard with its chipset and support...
CUA User Manual - Page 27
... the slot with the screw you removed above. 5. Replace the computer system's cover. 6. Set up the BIOS if necessary
(such as IRQ xx Used By ISA: Yes in PNP AND PCI SETUP) 7. Install the necessary software drivers for your expansion card.
3.7.2 Assigning IRQs for Expansion Cards
Some expansion cards need an IRQ to operate. Generally, an IRQ must be exclusively assigned...
CUA User Manual - Page 29
..., see your vendor or dealer.
3. H/W SETUP Expansion Cards
® CUA
To install the AMR card,
face its components
toward the serial ports.
CUA Audio Modem Riser Connector
3.7.4 TV/LCD Slot
This connector supports a specially designed TV/LCD slot to support an ASUS LCDTV daughter card. This card allows you to connect a digital flat panel, ASUS or third party TV or video accessories, such as...
CUA User Manual - Page 45
... disk. NOTE: BIOS setup must specify "Floppy" as the first item in the boot sequence.
4. In DOS mode, type A:\AFLASH to run AFLASH.
4. BIOS SETUP Updating BIOS
IMPORTANT! If "unknown" is displayed after Flash Memory:, the memory chip is either not programmable or is not supported by the ACPI BIOS and therefore, cannot be programmed by the Flash Memory Writer utility.
ASUS CUA User's Manual...
CUA User Manual - Page 49
... want to enable the Security Password Feature or make changes to the power management settings. It will then be necessary to reconfigure your system using the BIOS Setup program so that the computer can recognize these changes and record them in the CMOS RAM of the EEPROM.
The EEPROM on the motherboard stores the Setup utility. When you start up...
CUA User Manual - Page 68
... to add the statement, DEVICE=C:\DOS\POWER.EXE, to your CONFIG.SYS file. For Windows 3.x and Windows 95, you need to install Windows with the APM feature. For Windows 98 and later, APM is automatically installed. A battery and power cord icon labeled "Power Management" will appear in the "Control Panel." Choose "Advanced" in the Power Management Properties dialog box.
68
ASUS CUA User's Manual
CUA User Manual - Page 77
....
NOTE: Because there are various motherboard settings, options, and expansion cards, the following can only be used as a general reference and may not reflect exactly the screen contents displayed on your screen.
5. S/W SETUP Windows 98
NOTE: The screen displays in this and the following section may not reflect exactly the screen contents displayed on your screen.
ASUS CUA User's Manual
77
CUA User Manual - Page 78
...8226; ALi Audio Accelerator Driver: Installs ALI Audio Accelerator Driver • AMR Modem Driver: Installs AMR modem driver (PCtel HSP). • ASUS PC Probe Vx.xx: Installs a smart utility to monitor your computer's fan speed,
voltage, and CPU temperature. • ASUS Update Vx.xx: Installs ASUS Update to allow download of the latest BIOS for
your motherboard and other driver updates. •...
CUA User Manual - Page 79
... Miniport Driver
Insert the Support CD that came with your motherboard into your CD-ROM drive or double-click the CD drive icon in My Computer to bring up the setup screen.
(1) Click here.
Setup will automatically install the AGP Miniport Driver into your computer. To make use of the driver immediately, restart your system after the installation procedures are finished.
5. S/W SETUP Windows 98...
CUA User Manual - Page 89
... came with your motherboard into your CD-ROM drive or double-click the CD drive icon in My Computer to bring up the setup screen.
(1) Click here.
(2) Click here.
(3) Click here.
(4) Click here and follow the onscreen instructions to complete installation.
(5) Click here to install PowerDVD.
(6) Click here and follow the onscreen instructions to complete installation.
5. S/W SETUP Windows 98...
CUA User Manual - Page 98
... and Windows? • Were you able to install using the specified procedure?
No sound
• Is the MIDI driver correctly installed? • Is the tone generator set correctly? • Is volume set to zero in the XGstudio Player or XGstudio Mixer panels? • If you are using an external tone generator, is the serial or MIDI cable and the
audio cables...
CUA User Manual - Page 99
... a utility that allows you to update your motherboard's BIOS and drivers. The use of this utility requires that you are properly connected to the Internet through an Internet Service Provider (ISP). 1. Start ASUS Update. Launch the utility from Start | Programs | ASUS Utility | ASUS LiveUpdate.
2. Select an update method.
3. If you selected updating/downloading from the Internet, you will need to...
CUA User Manual - Page 104
...complete the environmental setting procedure.
6.7.2 CyberLink VideoLive Mail User Interface
Snapshot to File Video Configuration
Start Playback Stop Recording / Playback
Start Recording Pause
Exit Minimize Help Video Mail Wizard
Save Video File Send Mail
Load Video File
Send Mail Increase MIC volume Decrease MIC volume Increase speaker volume Decrease speaker volume
104
ASUS CUA User's Manual
CUA User Manual - Page 105
...REFERENCE Windows 98
6. SOFTWARE REFERENCE
6.7 ASUS Control Panel
The motherboard's built-in 2D/3D AGP VGA supports high-end professional graphics design, gaming, learning, and business applications.
NOTE: Depending on your system configuration, components, and options, your system may not show all of the settings displayed in the following pictures.
After installation of the display drivers, you...
CUA User Manual - Page 106
... color depth, for example, from 800x600 HiColor to 800x600 TrueColor. Click OK to restart your computer to make the change.
6.7.3 Information
Information lists the relevant information about your card. Aside from this, it has links to the ASUSTeK COMPUTER, INC. web site for updated information about the graphics board, latest drivers, and other information.
106
ASUS CUA User's Manual
CUA User Manual - Page 126
7. APPENDIX ASUS LAN Card
7. APPENDIX
7.1.1 Features
• Intel 82558 Ethernet LAN Controller (Fully integrated 10BASE-T/100BASE-TX) • Wake-On-LAN Remote Control Function Supported • PCI Bus Master Complies to PCI Local Bus Rev. 2.1 specifications • Consists of MAC & PHY (10/100Mbps) interfaces • Complies to IEEE 802.3 10BASE-T and IEEE 802.3u 100BASE-TX interfaces &#...
CUA User Manual - Page 128
...
7.2.4 Software Setup in Windows 98
The Modem Riser supports the Plug and Play feature. It allows your computer to automatically set the optimal configurations for the MR and communication software. Follow the procedure below to install the modem driver.
1. Power ON the computer after the hardware installation is completed.
2. Windows 98 will automatically detect the modem and display a "PCI Card...
CUA User Manual - Page 132
... for the OS. Since the contents of flash ROM can be modified, users are able to update the BIOS by themselves.
IDE (Integrated Drive Electronics) IDE devices integrate the drive control circuitry directly on the drive itself, eliminating the need for a separate adapter card (in the case for SCSI devices). UltraDMA/ 33 IDE devices can achieve up to 33MB/Sec transfer.
132
ASUS CUA User's Manual
CUA User Manual - Page 133
... user to change the card's IRQs and DMA in BIOS either automatically or manually.
POST (Power On Self Test) When you turn ON the computer, it will first run through the POST, a series of software-controlled diagnostic tests. The POST checks system memory, the motherboard circuitry, the display, the keyboard, the diskette drive, and other I/O devices.
PS/2 Port PS/2 ports are based on IBM...