Asus P I-P65UP5 C-PKND driver and firmware
Related Asus P I-P65UP5 C-PKND Manual Pages
Download the free PDF manual for Asus P I-P65UP5 C-PKND and other Asus manuals at ManualOwl.com
User Manual - Page 2
... each board design represented by the digit before and after the period of the manual revision number. Manual updates are represented by the third digit in the manual revision number. For updated BIOS, drivers, or product release information you may visit ASUS' home page at: http://www.asus.com.tw/
© Copyright 1996 ASUSTeK COMPUTER INC. All rights reserved.
Product Name: P/I-P65UP5
Manual...
User Manual - Page 4
... Card Installation Procedure 14 Assigning IRQs for Expansion Cards 14 Assigning DMA Channels for ISA Cards 15 ASUS MediaBus Card 16 5. External Connectors 17
IV. PCI-SC200 SCSI Card 23
NCR SCSI BIOS and Drivers 23 The PCI-SC200 SCSI Interface Card 24
Setting Up the PCI-SC200 24 Setting the INT Assignment 25 Terminator Settings 25 SCSI ID Numbers 26
IV
ASUS P/I-P65UP5 User's Manual
User Manual - Page 6
...dealer or an experienced radio/TV technician for help.
WARNING: The use of shielded cables for connection of the monitor to the graphics card is required to assure ...digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
VI
ASUS P/I-P65UP5 User's Manual
User Manual - Page 7
... items, please contact your retailer. √ The P/I-P65UP5 baseboard √ 2 serial port ribbon cables attached to a mounting bracket √ 1 parallel ribbon cable with mounting bracket √ 1 IDE ribbon cable √ 1 floppy ribbon cable √ This user's manual √ C-P6ND or C-P55T2D CPU card
Optional infrared module Optional PCI-SC200 SCSI card
ASUS P/I-P65UP5 User's Manual
1
User Manual - Page 8
... CD-ROM drives. This controller supports PIO Modes 3 and 4 and Bus Master IDE DMA Mode 2. BIOS supports IDE CD-ROM boot-up.
• Optional IrDA Module: This baseboard supports an optional infrared port module for wireless file transfers and communication.
• NCR SCSI BIOS: This baseboard has firmware that supports the optional ASUS PCI-SC200 SCSI controller cards.
2
ASUS P/I-P65UP5 User...
User Manual - Page 10
...Card Slot PCI Slot 1
Multi-I/O Enable/Disable
PCI Slot 2
PCI Slot 3
PCI Slot 4
BUS Freq.
CPU Card Slot
SIMM Socket 8 (Bank 3)
JP2 JP3
SIMM Socket 6 (Bank 2) SIMM Socket 4 (Bank 1) SIMM Socket 2 (Bank 0)
PCI Slot 5 / MediaBus 2.0 ISA Slot 1
ISA Slot 2 ISA Slot 3
III. INSTALLATION (Map of Board)
IDE LED
JP7 RTC RAM Operation/Clear
Infrared Con Case Connector
4
ASUS P/I-P65UP5 User's Manual
User Manual - Page 11
... (Map of Board)
III. INSTALLATION
Jumpers 1) JP1 2) JP4 3) JP2, 3 4) JP7
p. 7 Multi-I/O Selection (Enable/Disable) p. 7 Flash ROM Boot Block Program (Enable/Dis) p. 8 CPU External Clock (BUS) Frequency Select p. 9 Real Time Clock RAM (Operation/Clear Data)
Expansion Slots 1) SIMM Sockets 3) ISA Slots 1, 2, 3 4) PCI Slots 1, 2, 3, 4 5) PCI 5 / MediaBus
p. 10 DRAM Memory Expansion slots...
User Manual - Page 12
III. INSTALLATION (Jumpers)
III. INSTALLATION
Installation Steps
Before using your computer, you must complete the following steps:
1. Set Jumpers on the Baseboard 2. Install DRAM Memory Modules 3. Install the Central Processing Unit (CPU) Card 4. Install Expansion Cards 5. Connect Ribbon Cables, Cabinet Wires, and Power Supply 6. Setup the BIOS Software (see the CPU Card BIOS section)
1. ...
User Manual - Page 13
...INSTALLATION
Jumper Settings
1. On-Board Multi-I/O Selection (JP1) You can disable the onboard Multi-I/O (floppy, serial, parallel, and IrDA) individually through BIOS or entirely with the following jumper in order to use your own Multi-I/O card.
Multi-I/O Enable Disable
JP1 [1-2] (Default) [2-3]
JP1 1 2 3
Enable (Default)
JP1 1 2 3
Disabled
Multi I/O Setting (Enable / Disable)
2. Flash ROM...
User Manual - Page 14
...
BUS Ratio 3.0x 2.5x 2.5x 2.0x 2.0x 1.5x 1.5x 1.5x
(CPU Card BUS Ratio) Ext. JP15 JP16 Freq. [ON] [OFF] 66MHz [ON] [ON] 66MHz [ON] [ON] 60MHz [OFF] [ON] 66MHz [OFF] [ON] 60MHz [OFF] [OFF] 66MHz [OFF] [OFF] 60MHz [OFF] [OFF] 50MHz
(CPU Ext. Freq on Baseboard) JP3 JP2 [1-2] [2-3] [1-2] [2-3] [2-3] [1-2] [1-2] [2-3] [2-3] [1-2] [1-2] [2-3] [2-3] [1-2] [1-2] [1-2]
8
ASUS P/I-P65UP5 User's Manual
User Manual - Page 15
...Short this jumper, (3) Power on the PC, (4) Turn off the PC, (5) Remove this jumper, (6) Power on the PC, (7) Hold down during bootup and enter BIOS setup to re-enter user preferences.
Selections Operation Clear Data
JP7 [open] (Default) [short] (momentarily)
JP7
JP7
Operation (Default) Clear Data RTC RAM (Operation / Clear Data)
III. INSTALLATION (Jumpers)
ASUS P/I-P65UP5 User's Manual
9
User Manual - Page 16
... SIMM (e.g. 8 chips) and 36-bit SIMM (e.g. 12 chips) will work minus the ECC feature.
IMPORTANT: Memory setup is required in "Auto Configuration" in the CHIPSET FEATURES SETUP of Section IV BIOS software. Each bank must have the same size memory installed in pairs.
Install memory in any or all of the banks in any combination as follows:
Bank Bank 0 SIMM...
User Manual - Page 17
...which requires the "Notched End" of the SIMM memory modules.
2468
1357
III. INSTALLATION (DRAM Memory)
B0 B1 B2 B3
B0 B1 B2 B3
72 ...guides should go through the two "Mounting Holes" on the sides and the "Metal Clips" should snap on the other side.
5. To release the memory module, squeeze both "Metal Clips" outwards and rock the module out of the "Metal Clips".
ASUS P/I-P65UP5 User's Manual...
User Manual - Page 18
... can support a long PCI card on the first slot and that a groove is available for the bracket.
Installation procedures for the ASUS proprietary CPU card: 1. Remove the CPU card from its packaging without touching the integrated circuit (IC) chips and place it onto the antistatic bag. 2. Follow instructions in the CPU card manual on installing the processor(s), support bracket, and setting jumpers...
User Manual - Page 20
... from the bracket. 7. Replace the computer system's cover. 8. Setup the BIOS if necessary (such as "IRQ xx Used By ISA: Yes"
in PNP AND PCI SETUP) 9. Install the necessary software drivers for your expansion card.
Assigning IRQs for Expansion Cards
IMPORTANT: PCI Slots 4 & 5 share the same IRQ. If using PCI cards on both slots 4 & 5, make sure that the drivers support "Share IRQ" or that one...
User Manual - Page 21
... way as the IRQ assignment process described above. You can select a DMA channel in the PCI and PNP configuration section of the BIOS Setup utility.
IMPORTANT: In BIOS setup (see your CPU card manual), you should choose "Yes" for those IRQ's and DMA's you wish to reserve for Legacy (Non-PnP) ISA cards, otherwise conflicts may occur.
ASUS P/I-P65UP5 User's Manual
15
User Manual - Page 22
... be used on this baseboard:
• PCI-AS7870 • PCI-AV264CT • PCI-AV868
Fast/Wide SCSI & Audio MediaBus Card PCI Audio & Video MediaBus Card PCI Audio & Video MediaBus Card
* All the above Audio features Creative Technology, Ltd. * All the above Video features ATI, Inc. (AV868 Video features S3, Inc.) * All the above SCSI features Adaptec, Inc.
16
ASUS P/I-P65UP5 User's Manual
User Manual - Page 25
... secondary IDE connector. A new BIOS feature allows SCSI hard drive bootup (see "HDD Sequence SCSI/IDE First" in the BIOS FEATURES SETUP of the BIOS software). (Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).
Pin 1
III. INSTALLATION (Connectors)
Secondary IDE Connector Primary IDE Connector
6. Power connector (12-pin block) This...
User Manual - Page 27
... switch. Wake-up can be controlled by settings in the BIOS but the keyboard will always allow wake-up (the SMI lead cannot wake-up the system). If you want to use this connector, "Suspend Switch" in the POWER MANAGEMENT SETUP of the BIOS software should be on the default setting of Enable (see BIOS Power Management).
11. Reset switch...
User Manual - Page 29
... Drivers
Aside from the system BIOS, the Flash memory chip on the motherboard also contains the NCR SCSI BIOS. This SCSI BIOS works in conjunction with the optional PCI-SC200 SCSI controller card to provide a complete PCI Fast SCSI-2 interface.
All SCSI devices you install to your system require driver software to function. The NCR SCSI BIOS directly supports SCSI hard disks under the DOS, Windows...