Asus P2-P5945GC - P Series - 0 MB RAM driver and firmware
Drivers and firmware downloads for this Asus item
Related Asus P2-P5945GC Manual Pages
Download the free PDF manual for Asus P2-P5945GC and other Asus manuals at ManualOwl.com
P Series Installation manual for Multiple Languages - Page 1
English
P1-P5945G/P2-P5945G ASUS PC (Desktop Barebone)
Installation Manual
Download the latest manual from the ASUS website: www.asus.com
P Series Installation manual for Multiple Languages - Page 2
...45) port
4-pin IEEE 1394 port USB 2.0 ports Headphone port
Microphone port
USB 2.0 ports SPDIF Out port
VGA port DVI-D port
Serial port PCI slot metal brackets
* The system's power supply unit has a 115 V/230 V voltage selector switch located near the power connector. Use this switch to select the correct system input voltage according to the voltage supply in your area.
Installation manual
P Series Installation manual for Multiple Languages - Page 3
English
Internal components
3 4
1
5 8
6
2 7
1. 5.25-inch optical drive and 3.5 inch hard disk drive cage
2. Front panel cover
3. Power supply unit
4. PCI card riser bracket (connected to the motherboard PCI slot)
5. ASUS motherboard 6. DIMM sockets 7. LGA775 socket (under the CPU
fan and heatsink assembly) 8. CPU fan and heatsink assembly
Removing the cover
1. Remove the cover screws. Keep ...
P Series Installation manual for Multiple Languages - Page 4
...set it aside.
Removing the storage drive assembly
1. Lay the system on its side, then locate and remove three storage drive assembly screws.
2. Lift the storage drive assembly, then set aside.
Removing the CPU fan and heatsink
1. Disconnect the CPU fan cable.
2. Loosen the CPU fan and heatsink assembly screws.
3. Lift the CPU fan and heatsink assembly, then set aside.
Installation manual
P Series Installation manual for Multiple Languages - Page 5
... the PnP cap.
Retention tab
Load lever
3. Install the CPU. The CPU fits in only one orientation.
4. Close the load plate, then lock the load lever.
5. Reinstall the CPU fan and heatsink assembly, then reconnect the CPU fan cable to the CPU fan connector on the motherboard. Refer to the instructions in the previous section for details.
Installing a DIMM
1. Locate the DIMM sockets...
P Series Installation manual for Multiple Languages - Page 6
... the riser card connector sits properly on the motherboard PCI slot.
Installing optical and storage drives
1. Turn the storage drive assembly upside down with the 3.5-inch bay on top of the 5.25-inch bay.
2. Insert the optical drive upside down to the 5.25-inch bay, then secure it with two screws on both sides.
3. Turn the storage drive assembly, insert the hard disk drive upside...
P Series Installation manual for Multiple Languages - Page 7
...cable to the optical drive, then the gray plug to the hard disk drive. If you have the SATA HDD, connect the SATA cable to the SATA HD.
2. Connect the 4-pin power plugs to the power connectors at the back of the drives.
3. Install the storage drive assembly to the chassis. 4. Secure the storage drive assembly with three screws.
3
4
Installing... disengages from the chassis.
Installation manual
P Series Installation manual for Multiple Languages - Page 8
... the chassis, then close.
2. Insert the front panel cover
hooks to the chassis tabs until
the front panel cover fits in
place.
Reinstalling the cover
1. Install the cover to the chassis. Make sure the cover tabs fit the chassis rails. 2. Push the cover toward the front panel until it fits in...