Asus P5E-VM DO NA driver and firmware
Related Asus P5E-VM DO NA Manual Pages
Download the free PDF manual for Asus P5E-VM DO NA and other Asus manuals at ManualOwl.com
User Manual - Page 2
... both printed on the board itself. Manual revisions are released for each board design represented by the digit before and after the period of the manual revision number. Manual updates are represented by the third digit in the manual revision number. For previous or updated manuals, BIOS, drivers, or product release information you may visit ASUS' home page at: http://www.asus.com.tw/ or...
User Manual - Page 4
... (CPU 19 4. Expansion Cards 20 Expansion Card Installation Procedure 20 Assigning IRQs for Expansion Cards 20 Assigning DMA Channels for ISA Cards 21 5. External Connectors 22 Power Connection Procedures 31
IV. BIOS SOFTWARE 32 Support Software 32 Flash Memory Writer Utility 32 Main Menu 32 Advanced Features Menu 33 Managing & Updating your Motherboard's BIOS 34 6. BIOS Setup 35 Load...
User Manual - Page 5
CONTENTS
V. SUPPORT SOFTWARE 54 Desktop Management Interface (DMI 54 Introducing the ASUS DMI Configuration Utility 54 System Requirements 54 Using the ASUS DMI Configuration Utility 55 Notes 55
VI. ASUS PCI-SC200 SCSI Card 57 SCSI BIOS and Drivers 57 The ASUS PCI-SC200 SCSI Interface Card 58 Setting Up the ASUS PCI-SC200 58 Setting the INT Assignment 59 Terminator Settings 59 SCSI ID ...
User Manual - Page 7
... this product
III. Installation:
Instructions on setting up the motherboard.
IV. BIOS Setup: BIOS software setup information.
V. Support Software: Installation of software drivers and utilities.
VI. ASUS PCI-SC200: Installation of an optional Fast-SCSI card.
VII. ASUS I-A16C: Installation of an optional 16-bit Audio card
VIII. Windows 95: Audio Software Manual (ASUS I-A16C Audio bundle)
IX...
User Manual - Page 8
... data transfer rates, and supports Enhanced IDE devices such as Tape Backup and CD-ROM drives. This controller supports PIO Modes 3 and 4 and Bus Master IDE DMA Mode 2. BIOS now supports IDE CDROM or SCSI bootup.
• Level 2 Cache: 256 or 512KB Pipelined Burst SRAM onboard.
• Optional PS/2 Mouse, USB, IrDA Connector: Supports an optional cable and bracket set to mount the connectors...
User Manual - Page 11
...5) BF0, BF1
p. 13 Flash ROM Boot Block Program (Disable/Enable) p. 14 Real Time Clock RAM (Operation/Clear Data) p. 15 CPU Voltage Selection p. 16 CPU External Clock (BUS) Frequency Selection p. 16 CPU:BUS Frequency Ratio
Expansion Slots
1) System Memory 2) SIMM Sockets 3) ZIF Socket 7 4) PCI Slots 5) ISA Slots
p. 17 System Memory Upgrade p. 18 72-Pin SIMM Memory Expansion Sockets p. 19 Central...
User Manual - Page 12
III. INSTALLATION (Jumpers)
III. INSTALLATION
Installation Steps
Before using your computer, you must complete the following steps:
1. Set Jumpers on the Motherboard 2. Install DRAM Modules 3. Install the Central Processing Unit (CPU) 4. Install Expansion Cards 5. Connect Ribbon Cables, Cabinet Wires, and Power Supply 6. Setup the BIOS Software
1. Jumpers
Several hardware settings are made ...
User Manual - Page 13
... the Programmable Flash ROM to allow programming in the Enabled position. This is required only if prompted by the Flash Memory Writer Utility as shown in BIOS SOFTWARE.
Programming BBLKW
Disabled [1-2] (Default)
Enabled
[2-3]
R
BBLKW
1 2 3
Disabled / Protected (Default)
BBLKW 1 2 3
Enabled
Boot Block Programming (Disable / Enable)
III. INSTALLATION (Jumpers)
ASUS HX97 User's Manual
13
User Manual - Page 17
... must be installed in pairs so that each Row (see Map of Motherboard for Row locations) contains 64-bits of the same size and type of memory chips. One side (with memory chips) of the SIMM module takes up half a Row on the motherboard.
IMPORTANT: Memory speed setup is required through "Auto Configuration" in BIOS Chipset Setup of the BIOS SOFTWARE. If...
User Manual - Page 20
... the slot with the screw you removed in step 4. 7. Replace the computer system's cover. 8. Setup the BIOS if necessary
(such as "IRQ xx Used By ISA: Yes" in PNP AND PCI SETUP) 9. Install the necessary software drivers for your expansion card.
Assigning IRQs for Expansion Cards
Some expansion cards need to use an IRQ to operate. Generally an IRQ must be...
User Manual - Page 21
... configure the card's jumpers manually and then install it in any available slot on the ISA bus. You may use Microsoft's Diagnostic (MSD.EXE) utility included in the Windows directory to see a map of your used and free IRQs. For Windows 95 users, the "Control Panel" icon in "My Computer," contains a "System" icon which gives you a "Device Manager" tab...
User Manual - Page 23
... through "Onboard Parallel Port" in Chipset Features of the BIOS SOFTWARE. (Pin 26 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 26 plugged).
NOTE: Serial printers must be connected to the serial port.
R R
Pin 1
For this connector to be available, you must connect the included Parallel (25-Pin female) cable set to a free expansion...
User Manual - Page 31
... 30 seconds from the time you turn on the power, the system may have failed a power-on test. Recheck your jumper settings and connections or call your retailer for assistance.
7. During power-on, hold down the key to enter BIOS setup. Follow the next section "BIOS SOFTWARE" for instructions.
* Powering Off your computer: You must first exit or shut down your...
User Manual - Page 34
..." is displayed after "Flash type --," then this ROM chip is not programmable or not supported with the PnP BIOS and therefore cannot be programmed by the Flash Memory Writer.
1. Download an updated ASUS BIOS file from the internet (WWW), FTP, or a BBS (Bulletin Board Service) and save to the diskette you created above. See ASUS CONTACT INFORMATION on Page II of the User's Manual for details...
User Manual - Page 35
IV. BIOS SOFTWARE
6. BIOS Setup
The motherboard supports two programmable Flash ROM chips: 5 Volt and 12 Volt. Either of these memory chips can be updated when BIOS upgrades are released. Use the Flash Memory Writer utility to download the new BIOS file into the ROM chip as described in detail in this section.
All computer motherboards provide a Setup utility program for specifying the system ...
User Manual - Page 37
... here since they operate using device drivers and are not supported by any the BIOS. If you install the optional PCI-SC200 SCSI controller card into the motherboard (see section VI for instructions). If you install other vendor's SCSI controller card, please refer to their respective documentations on how to install the required SCSI drivers.
For IDE hard disk drive setup, you can: • Use the...
User Manual - Page 46
... allows you to set power saving options according to your preference.
IMPORTANT: Advanced Power Management (APM) should be installed to keep the system time updated when the computer enters suspend mode activated by the BIOS Power Management. For DOS environments, you need to add DEVICE=C:\DOS\POWER.EXE in you CONFIG.SYS. For Windows 3.x and Windows 95, you need to install Windows with the...
User Manual - Page 54
... and record information pertinent to a computer's system such as the CPU type, CPU speed, and internal/external frequencies, and memory size. The onboard BIOS will detect as many system information as possible and store those collected information in a 4KB block in the motherboard's Flash EPROM and allow the DMI to retrieve data from this database. Unlike other BIOS software, the BIOS...
User Manual - Page 57
...and Drivers
Aside from the system BIOS, the Flash memory chip on the motherboard also contains the SCSI BIOS. This SCSI BIOS works in conjunction with the optional ASUS PCI-SC200 SCSI controller card to provide a complete PCI Fast SCSI-2 interface.
All SCSI devices you install to your system require driver software to function. The SCSI BIOS directly supports SCSI hard disks under the DOS, Windows...
User Manual - Page 61
...ISA audio card comes with certain motherboard bundles only and is not for sale separately.
ASUS I-A16C Audio Features
• Creative Labs ViBRA 16C PnP Audio Chip • Full Duplex Supports • 16/8 bit PCM 5KHz to 44.1KHz • Wave Table Upgradeable • Software Includes:
DOS and Window 3.1 Drivers Windows 95 Driver Wave Editor Wave OLE Quick CD Mixer Control Quick Player
Unpacking...