Asus V2-AH2 driver and firmware
Related Asus V2-AH2 Manual Pages
Download the free PDF manual for Asus V2-AH2 and other Asus manuals at ManualOwl.com
Quick Installation Guide - Page 2
... user guide for installation details and other system information from ASUS website.
Front panel features
3.5-inch drive bay cover
5.25-inch drive bay cover
USB 2.0 ports Microphone port Headphone port
Rear panel features
IEEE 1394 port Power button Reset button HDD LED
Power connector Voltage selector
PS/2 mouse port PS/2 keyboard port
DVI connector Parallel port VGA port
IEEE 1394 port USB...
Quick Installation Guide - Page 3
... 10
R
12 13
2
3 1
4
1. Front panel cover 2. 5.25-inch optical drive bays 3. Hard disk drive bay 4. Floppy disk drive bay 5. Power supply unit 6. CPU socket 7. DIMM sockets
8. ASUS motherboard 9. Chassis fan 10. PCI Express x16 slot 11. PCI Express x1 slot 12. PCI slots 13. Metal bracket lock
Selecting the voltage
The system's power supply unit has a 115 V/230 V voltage selector switch located...
Quick Installation Guide - Page 4
... of the assembly are exposed. 5. Remove the front panel assembly, then set aside.
4 3
Air duct
1
4
2
3
1
4
2
3
Chassis tab holes
4
Installing a CPU
1. Locate the CPU socket, then lift the socket lever to a 90º-100º angle. 2. Install the CPU to the socket, making sure that the CPU corner with
the gold triangle matches the socket corner with a small...
Quick Installation Guide - Page 5
... fan and heatsink to the module retention module base.
5. Connect the CPU fan cable to the connector on the motherboard.
CAUTION. Do not forget to connect the CPU fan connector! Hardware monitoring error can occur if you fail to plug this connector.
CPU fan
Retention bracket lock
Retention bracket 3
1 2
4
5
CPU fan connector
CPU heatsink
Retention module base
Quick installation guide
Quick Installation Guide - Page 6
... the retaining clips snap inward.
• Unplug the power supply before adding or removing DIMMs. Failure to do so may cause damage to the motherboard and/or components.
• A DDR2 DIMM is ...keyed with a notch so that it fits in only one direction. Do not force a DIMM into a socket to avoid damaging the DIMM.
Installing an expansion card
...
Quick Installation Guide - Page 7
Installing storage drives
Optical drive
1. Place the chassis upright, then
remove the upper 5.25" drive
3
bay metal plate cover.
2. Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay.
3. Secure the optical drive with two screws on both sides of the bay.
4. Connect the IDE (A) and power (B) plugs to connectors...
Quick Installation Guide - Page 8
... the SATA signal and power plugs to
SATA
IDE
the connectors at the back of
the drive.
For IDE HDD: Connect the IDE signal and power plugs to the connectors at the back of the drive.
Removing the bay covers and reinstalling the
front panel assembly and side cover
If you installed an optical and/or floppy disk drive, remove...