Biostar P4TGT driver and firmware
Related Biostar P4TGT Manual Pages
Download the free PDF manual for Biostar P4TGT and other Biostar manuals at ManualOwl.com
P4TGT user's manual - Page 1
...a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates..., uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful...
P4TGT user's manual - Page 3
...PS/2 keyboard port, audio ports, USB ports and a game port. Supports the Intel Pentium 4® (Socket 478) processor up to 2.8GHz. Supports Intel Pentium 4 processor with Hyper-Threading. Supports Ultra 100/66/33, DMA and PIO modes. Supports up to 2 DDR266/333 MHz devices, running at 400/533 MHz Front Side Bus frequency. Supports a maximun memory size up to 2GB. Supports five 32-bit PCI Bus slots...
P4TGT user's manual - Page 4
MMootthheerrbbooaarrdd DDeessccrriippttiioonn
Support SPDIF-Out. Supports Hardware Audio 6CH Audio (Optional). Line-in phone-jack share with rear out . Mic-in phone-jack share with Bass and Center.
Package contents
HDD Cable X 1 FDD Cable X 1 Fully Setup Driver CD X 1 USB Cable X 2 (Optional)
2
P4TGT user's manual - Page 6
... the white dot or cut edge in the CPU. Match Pin A with the white dot/cut edge then insert the CPU.
3. Press the lever down. Then Put the fan on the CPU and buckle it and put the fan's power port into the JCFAN1, then to complete the installation.
CPU/ System Fan Headers: JCFAN1/ JSFAN1
12V Ground...
P4TGT user's manual - Page 7
...DDR SDRAM DIMMs. Does not support double-size x16 DDR DIMMs. DRAM Type: 64MB/ 128MB/ 256MB/ 512MB/ 1GB DIMM Module (184 pin)
DIMM Socket Location
DDR Module
Total Memory Size (MB)
DDR 1
64MB... is only for reference. If use FSB 400MHz CPU, the memory run only at DDR200/266. If use FSB 533MHz CPU, the memory run only at DDR266/333.
How to install a DIMM Module
1. The DIMM socket has a...
P4TGT user's manual - Page 12
...: JPANEL1
PWR_LED
SLP
(+) (+) (-) ON/OFF
IR
2
24
1
23
SPK
SPK
(+) (-)
RST
IR
HLED
==> Speaker Conn.
HLED ==> Hard Driver LED
RST
==> Reset Button
IR
==> Infrared Conn.
SLP
==> Sleep Button
PWR_LED ==> Power LED
ON/ OFF ==> Power-on Button
Back Panel Connectors
JKBMS1
PS/2 Mouse
JPRNT1
JGAME1
Game Port
PS/2
USB
COM1
Mic
Keyboard
JCOM1
JVGA1
In
10
P4TGT user's manual - Page 26
MMootthheerrbbooaarrdd DDeessccrriippttiioonn
System Requirement
OS Support: Windows 98 SE, Windows Me, Windows 2000, Windows XP DirectX: DirectX 8.1 or above. (The Windows XP operating system includes DirectX 8.1. If you use Windows XP, you do not need to install DirectX 8.1.)
Installation
1. Execute the setup execution file, and then the following dialog will pop up. Please click "Next" button ...
P4TGT user's manual - Page 28
... only for reference, the screen printed in this usr manual will change according to your motherboard on hand. [ WarpSpeeder™ ] includes 1 tray icon and 5 panels: 1. Tray Icon: Whenever the Tray Icon utility is launched, it will display a little tray icon on the right side of Windows Taskbar.
This utility is responsible for conveniently invoking...
P4TGT user's manual - Page 29
..., [ WarpSpeeder™ ] utility will be invoked. Please refer do the following figure; the utility's first window you will see is Main Panel.
Main Panel contains features as follows:
a. Display the CPU Speed, CPU external clock, Memory clock, AGP clock, and PCI clock information. b. Contains About, Voltage, Overclock, and Hardware Monitor Buttons for invoking respective panels. c. With...
P4TGT user's manual - Page 36
...
power indicator lights are lit, hard drive is DIMM, press down firmly until the module
spinning.
snaps into place.
PROBABLE CAUSE
SOLUTION
System does not boot from hard disk drive, can * Check cable running from disk to disk
be booted from CD-ROM drive.
controller board. Make sure both ends are
securely plugged in; check the drive type in
the standard CMOS setup...