Brother International Pacesetter PS21 driver and firmware
Drivers and firmware downloads for this Brother International item
Related Brother International Pacesetter PS21 Manual Pages
Download the free PDF manual for Brother International Pacesetter PS21 and other Brother International manuals at ManualOwl.com
Users Manual - English - Page 8
... plug must be removed from the socket outlet.
● When servicing the machine, removing covers or changing bulbs, the machine must be... electrician to install the proper outlet. Do not modify the plug in any way.
Foot Controller
When you press the foot controller down lightly,... main power switch off before you change the needle. If you leave the main power on and step on the foot controller, the...
Users Manual - English - Page 9
... needle bar to its highest position.
2
Lower the presser foot.
3
If a needle is already installed, remove it by 4 loosening the needle clamp with a
screwdriver and pulling the needle down.
1...Changing the Presser Foot
CAUTION
● Always turn off the power before you change the presser foot. If you leave the power on and step on the controller, the machine will start and you may be injured.
&#...
Users Manual - English - Page 10
... the front right-hand side of the base plate to adjust it until the machine is stable.
CAUTION
● If the presser foot is not installed with the correct orientation, the needle may strike the presser foot, which may bend or break the needle and cause injury.
9
Users Manual - English - Page 33
...
1
1 Front of chalk mark 2 Red lines
CAUTION
● If the presser foot is not installed with the correct orientation, the needle may strike the presser foot, bending or breaking the needle and...
to cut through any stitches.
Step
Step 1 (Front bar tack)
Sewn section
a
Pattern
a/c c
a
1. Set the pattern selection dial to "a". 2. Lower the presser foot and sew 5 to 6 stitches. 3. Stop the ...
Users Manual - English - Page 39
... screw.
5
Loosen the face plate screw.
2
Remove the face plate from the machine as 3 shown below.
Oiling
Remove the power supply plug from the 1 outlet.
Remove the needle plate and the face plate, 2 and then put 2 to 3 drops of....
4
1 2
3
1 Bulb 2 Loosen 3 Tighten
Operate the machine at a fast speed for a 3 short time without thread installed.
Be sure to wipe any excess oil off the 4 machine.
38
Users Manual - English - Page 40
... the hook by grasping its center post 5 and pulling it out.
3 5
2
4
1
1
1 Retaining ring 2 Latch lever 3 Hook 4 Driver 5 Race body
■ Cleaning the Shuttle Race Remove any accumulated lint and thread from
1 the retaining ring, hook, driver and race body with a brush.
Wipe lint from the shuttle race using a cloth 2 dampened with machine...
Users Manual - English - Page 41
...difficulties are encountered, first review the manual section about the operation that you... improve the operation. If you still have difficulties, contact your nearest service center.
UPPER THREAD BREAKS
LOWER THREAD BREAKS
SKIPPED STITCHES
LOOP IN SEAM...fabric is incorrect.
Page 24 No
Spool of thread is not correctly installed.
Lower threading is not correct.
Lint is clinging to the bottom ...