Dell Latitude E6440 driver and firmware
Related Dell Latitude E6440 Manual Pages
Download the free PDF manual for Dell Latitude E6440 and other Dell manuals at ManualOwl.com
Dell Owners Manual - Page 2
... Dell Inc. Intel®, Pentium®, Xeon®, Core® and Celeron® are registered trademarks of Intel Corporation in the U.S. and other countries. AMD® is a registered trademark and AMD Opteron™, AMD Phenom™ and AMD Sempron™ are trademarks of Advanced Micro Devices, Inc. Microsoft®, Windows®, Windows Server®, Internet...
Dell Owners Manual - Page 3
... Digital (SD) Card...12 Installing the Secure Digital (SD) Card...12 Removing the ExpressCard...13 Installing the ExpressCard...13 Removing the Battery...13 Installing the Battery...13 Removing the Base Cover...14 Installing the Base Cover...14 Removing the Memory...14 Installing the Memory...15 Removing the Hard Drive...15 Installing the Hard Drive...16 Removing the Optical Drive...16 Installing...
Dell Owners Manual - Page 4
...Bezel...42 Removing the Display Panel...42 Installing the Display Panel...44 Removing the Display Hinges...44 Installing the Display Hinges...45 Removing the Camera...45 Installing the Camera...46
3 System Setup...47
Boot Sequence...47 Navigation Keys...47 System Setup Options...48 Updating the BIOS ...57 System and Setup Password...57
Assigning a System Password and Setup Password 58 Deleting or...
Dell Owners Manual - Page 7
... Turn off your computer (see Turning Off Your Computer). 3. If the computer is connected to a docking device (docked) such as the optional Media Base or Battery Slice,
undock it.
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device. 4. Disconnect all network cables from the computer. 5. Disconnect your computer and all...
Dell Owners Manual - Page 8
... internal components.
11. Remove any installed ExpressCards or Smart Cards from the appropriate slots.
Turning Off Your Computer
CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
1. Shut down the operating system: - In Windows 8: * Using a touch-enabled device: a. Swipe in from the right...
Dell Owners Manual - Page 11
2
Removing and Installing Components
This section provides detailed information on how to remove or install the components from your computer.
System Overview
Figure 1. Back View - Back Cover Removed
1. base corner caps 2. power connector 3. heatsink assembly 4. memory module 5. SD card 6. ExpressCard slot
7. optical drive 8. WLAN card 9. coin-cell battery 10. WWAN card
11
Dell Owners Manual - Page 12
... Assembly removed
1. WiFi-switch board 2. ExpressCard cage 3. speakers 4. hard-drive bay
5. system board 6. I/O board
Removing the Secure Digital (SD) Card
1. Follow the procedures in Before Working Inside Your Computer. 2. Press in on the SD card to release it from the computer. Slide the SD card out of the computer.
Installing the Secure Digital (SD) Card
1. Slide the SD card into its slot...
Dell Owners Manual - Page 13
... slot until it clicks in place. 2. Follow the procedures in After Working Inside Your Computer.
Removing the Battery
1. Follow the procedures in Before Working Inside Your Computer. 2. Slide the release latches and flip the battery out of the computer.
Installing the Battery
1. Slide the battery into its slot until it clicks into place. 2. Follow...
Dell Owners Manual - Page 14
... cover to the computer. 3. Install the battery. 4. Follow the procedures in After Working Inside Your Computer.
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) battery b) base cover 3. Pry the securing clips away from the memory module until it pops-up and remove the memory module from its connector on the system board.
14
Dell Owners Manual - Page 15
... to secure the memory module to the system board. 3. Install:
a) base cover b) battery 4. Follow the procedures in After Working Inside Your Computer.
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the battery. 3. Remove the screws that secure the hard drive to the computer. Slide the hard drive out of the computer.
4. Remove the screw...
Dell Owners Manual - Page 16
...hard drive to the computer. 6. Install the battery. 7. Follow the procedures in After Working Inside Your Computer.
Removing the Optical Drive
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the battery. 3. Perform the steps as shown in the illustration:
a) Press the optical-drive latch. b) Release the optical drive. c) Pull the optical drive from the computer.
4. Remove...
Dell Owners Manual - Page 17
...-drive latch bracket to the optical drive. 3. Slide the optical-drive latch in the optical-drive latch bracket. 4. Tighten the screws to secure the optical-drive latch to the optical-drive latch bracket. 5. Slide the optical drive into the drive bay. 6. Press the optical-drive latch to secure the optical drive. 7. Install the battery. 8. Follow the procedures in After Working Inside Your Computer...
Dell Owners Manual - Page 18
... trim to its slot. 2. Press along the sides of the keyboard trim until it clicks in place. 3. Install battery. 4. Follow the procedures in After Working Inside Your Computer.
Removing the Keyboard
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the:
a) battery b) keyboard trim 3. Remove the screws on the back of the...
Dell Owners Manual - Page 19
... the keyboard cable from the system board.
Installing the Keyboard
1. Connect the keyboard cable to the system board. 2. Slide the keyboard into its compartment until it clicks into place. 3. Tighten the screws to secure the keyboard to the palmrest assembly. 4. Flip the computer and tighten the screws on the back of the computer. 5. Install the keyboard trim. 6. Install the...
Dell Owners Manual - Page 20
... the procedures in Before Working Inside Your Computer. 2. Remove:
a) battery b) base cover 3. Perform the following steps: a) Disconnect the antenna cables from the WLAN card. b) Remove the screw that secures the WLAN card to the system board. c) Remove the WLAN card from the computer.
Installing the WLAN Card
1. Insert the WLAN card in its connector at a 45-degree angle in its...
Dell Owners Manual - Page 21
Installing the WWAN Card
1. Place the WWAN card in its slot in the system board. 2. Press the WWAN card down and tighten the screw to secure the WWAN card to the computer. 3. Connect the antenna cables to their connectors on the WWAN card. 4. Install:
a) base cover b) battery 5. Follow the procedures in After Working Inside Your Computer.
Removing the Base Corner Caps
1. Follow...
Dell Owners Manual - Page 22
... computer. 3. Install:
a) base cover b) battery 4. Follow the procedures in After Working Inside Your Computer.
Removing the Network Connector
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) battery b) base cover c) base corner cap (left) 3. Perform the following steps as shown in the illustration: a) Disconnect the cable from the system board [1]. b) Release cable...
Dell Owners Manual - Page 23
Installing the Network Connector
1. Align the network connector to its position on the computer. 2. Place the network-connector bracket on the network connector. 3. Tighten the screw to secure the network-connector bracket to the computer. 4. Route the cable through the routing channel. 5. Connect the cable to the system board. 6. Install:
a) base corner cap (left) b) base cover c) battery 7. ...
Dell Owners Manual - Page 57
... the log. Displays the power events and allows you to clear the log.
Updating the BIOS
It is recommended to update your BIOS (system setup), on replacing the system board or if an update is available. For laptops, ensure that your computer battery is fully charged and connected to a power outlet
1. Restart the computer. 2. Go to dell.com/support. 3. If you have your computer's Service Tag or...
Dell Setup and Features Information - Page 4
...Connect the network cable (optional).
Figure 5. Network Connector 3. Connect USB devices, such as a mouse or keyboard (optional).
Figure 6. USB Connector 4. Open the computer display and press the power button to turn on the computer.
Figure 7. Power Button
NOTE: It is recommended that you turn on and shut down your computer at least once before you install any cards or connect the computer to...