Dell PowerConnect 5012 driver and firmware
Related Dell PowerConnect 5012 Manual Pages
Download the free PDF manual for Dell PowerConnect 5012 and other Dell manuals at ManualOwl.com
System Information Guide - Page 4
... Corporation. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and PowerConnect are trademarks of Dell Computer Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation; EMC is the registered trademark of EMC corporation...
System Information Guide - Page 8
www.dell.com | support.dell.com
Caution: Safety Instructions (continued)
• Use only approved power cable(s). If you have not been provided with a power cable for your system or for any AC-powered option intended for your system, purchase a power cable that is approved for use in your country. The power cable must be rated for the product and for the voltage and current...
System Information Guide - Page 9
...rack kits are intended to be installed in a rack by trained service technicians. If you install the kit in any other rack, be sure that the rack meets the specifications of a Dell rack. CAUTION: Do not move...the rack. • Do not overload the AC supply branch circuit that provides power to the rack. The
total rack load should not exceed 80 percent of the branch circuit rating. • Ensure that...
System Information Guide - Page 10
... Do not plug a modem or telephone cable into the network interface controller (NIC)
receptacle. • Disconnect the modem cable before opening a product enclosure, touching or
installing internal components, or touching an uninsulated modem cable or jack.
When Working Inside Your System
Protecting Against Electrostatic Discharge
NOTICE: Only a certified service technician should perform repairs...
System Information Guide - Page 11
... such batteries, refer to the documentation for the specific card or component.
About This Guide
This document contains getting started/setup, safety, regulatory, and warranty information about your Dell™ PowerConnect™ network switch. To obtain the latest versions of the documents on your hard drive, go to the Dell Support website at support.dell.com.
PowerConnect System Information...
System Information Guide - Page 12
....
• Get help with general usage, installation, and troubleshooting questions.
• Obtain answers to technical service and support questions.
• Get the latest versions of the drivers for your system.
• Access documentation about your system and devices.
• Join online discussions with other Dell customers and Dell technical professionals.
• Explore a list of...
System Information Guide - Page 13
... rack installation • Dell PowerConnect CD
Before You Connect to the Network: Mounting Kit Instructions
NOTICE: Do not connect the switch to the network until you have established the correct Internet Protocol (IP) settings.
Before you connect to the network, you must install the switch on a flat surface or in a rack, set up a terminal emulation program, and plug in the power cable. Then...
System Information Guide - Page 14
... the other end of the cable to a terminal or the serial connector of a desktop system running terminal emulation software. Ensure the terminal emulation software is set as follows: a Select the appropriate serial port (serial port 1 or serial port 2). b Set the data rate to 9600 baud. c Set the data format to 8 data bits, 1 stop bit, and no parity. d Set flow control to none. e Under Properties...
System Information Guide - Page 18
..., expansion cards, printers, input/output (I/O) devices, monitors, and so on, that are integrated into or connected to the system should match the electromagnetic environment classification of the computer system.
A Notice About Shielded Signal Cables: Use only shielded cables for connecting peripherals to any Dell device to reduce the possibility of interference with radio communications services...
System Information Guide - Page 20
... a socket with an attached protection circuit (a 3-prong socket). All equipment that works together (computer, monitor, printer, and so on) should have the same power supply source. The phasing conductor of the room's electrical installation should have a reserve short-circuit protection device in the form of a fuse with a nominal value no larger than 16 amperes (A). To...
System Information Guide - Page 163
... modem
RS-232
Ænone VT100 for Emulation Properties Ctrl keys≠ Arrow ¨Function ¯Â·Ú Terminal keys Windows keys Terminal keys
HyperTerminal
Windows 2000 Microsoft® Windows®2000 Windows 2000 Service Pack 2 Service Pack
Ï˘ VT100 www.microsoft.com HyperTerminal
ÆWindows 2000 service pack
PowerConnect...