Dell PowerEdge 2500SC driver and firmware
Related Dell PowerEdge 2500SC Manual Pages
Download the free PDF manual for Dell PowerEdge 2500SC and other Dell manuals at ManualOwl.com
Attaching
Casters to Your Dell System (.pdf) - Page 2
... reserved. Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of Dell Computer Corporation; Intel is a registered trademark of Intel Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade...
Attaching
Casters to Your Dell System (.pdf) - Page 3
... all data on the hard-disk drives before changing the mode of operation of the integrated SCSI controller from SCSI to RAID. 1 Turn off the system, including any attached peripherals, and disconnect the AC power cable from its power source. 2 Open the front bezel. See "Removing the Front Bezel" in your system Installation and Troubleshooting Guide.
3 Remove the system cover. 4 Remove...
Attaching
Casters to Your Dell System (.pdf) - Page 4
www.dell.com | support.dell.com
Figure 1-1. Installing the RAID Controller Memory Module
memory module socket ejectors (2)
alignment keys (2)
6 To install the memory module provided in your upgrade kit, align the memory module's edge connector with the memory module socket, and insert the memory module in the socket (see Figure 1-1).
The socket has two alignment keys that allow the memory ...
Attaching
Casters to Your Dell System (.pdf) - Page 5
Figure 1-2. Installing the RAID Hardware Key
9 Install the RAID battery: a Hook the front edge of the RAID battery assembly into the slot near the system board, then snap the clip on the back edge of the battery assembly into place so the battery lies flat (see Figure 1-3).
Figure 1-3. Installing the RAID Battery RAID battery
Activating the Integrated RAID Controller
1-3
Attaching
Casters to Your Dell System (.pdf) - Page 6
www.dell.com | support.dell.com
b Connect the battery cable to the RAID battery connector on the system board (see the system information label on the inside of the system cover for the location of this connector).
c Install the peripheral bay. See "Installing the Peripheral Bay" in the system Installation and Troubleshooting Guide.
10 Replace the cooling shroud and system cover...
Microprocessor
Upgrade Installation Guide (.pdf) - Page 9
www.dell.com | suppor t.dell.com
SCSI
SCSI (Small Computer System Interface) SCSI
:
2 × 3
Dell™
1
:
2 SCSI 3
4
5 a
b c
( Installation and Troubleshooting Guide )
( Installation and Troubleshooting Guide )
( 5-1
)
SCSI
d
6 ( 5-1
7 SCSI
) 2 × 3
SCSI
( 5-1
)
SCSI
Microprocessor
Upgrade Installation Guide (.pdf) - Page 10
www.dell.com | suppor t.dell.com
5-1: SCSI SCSI
SCSI
8
( Installation and Troubleshooting Guide
)
9
( Installation and Troubleshooting Guide
)
10
11
Installation and Troubleshooting Guide
© 2001
Dell Computer Corporation
Printed on recycled paper.
Dell DELL
Dell Computer Corporation
Printed in Malaysia. Dell Computer Corporation