Dell Precision T3600 driver and firmware
Related Dell Precision T3600 Manual Pages
Download the free PDF manual for Dell Precision T3600 and other Dell manuals at ManualOwl.com
- Page 4
... active when a second CPU is installed.
Back Panel
Figure 4. Back Panel View
1. line-out connector 2. network link integrity light 3. network adapter connectors (2) 4. network activity light 5. PS/2 mouse connector 6. USB 2.0 connector
7. line-in/microphone connector 8. serial connector 9. USB 2.0 connectors (4) 10. PS/2 keyboard connector 11. USB 3.0 connector
Quick Setup
WARNING: Before you...
- Page 8
... is available at support.dell.com/manuals.
Information in this publication is subject to change without notice. © 2012 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell™, the DELL logo, Dell Precision™, Precision ON™, ExpressCharge...
Owner's Manual - Page 2
... Association (BDA) and licensed for use on discs and players. The Bluetooth® word mark is a registered trademark and owned by the Bluetooth® SIG, Inc. and any use of such mark by Dell Inc. is under license. Wi-Fi® is a registered trademark of Wireless Ethernet Compatibility Alliance, Inc. 2012 - 05 Rev. A01
Owner's Manual - Page 3
...)...7 Installing the Power Supply Unit (PSU)...8 Removing the Cover...8 Installing the Cover...9 Removing the Optical Drive ...9 Installing the Optical Drive ...12 Removing the Thermal Sensor...12 Installing the Thermal Sensor...12 Removing the Hard Drive...12 Installing the Hard Drive ...14 Removing the System Fan...14 Installing the System Fan...19 Removing the Memory...19 Installing the Memory...
Owner's Manual - Page 4
......33 Removing the System Board...33 Installing the System Board...35 System Board Components...35
3 Additional Information...37
Memory Module Guidelines...37 Power Supply Unit (PSU) Lock...37
4 System Setup...39
Boot Sequence...39 Navigation Keys...39 System Setup Options...40 Updating the BIOS ...45 System and Setup Password...46
Assigning a System Password and Setup Password 46 Deleting or...
Owner's Manual - Page 5
... Off Your Computer).
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device. 3. Disconnect all network cables from the computer. 4. Disconnect your computer and all attached devices from their electrical outlets. 5. Press and hold the power button while the computer is unplugged to ground the system board. 6. Remove the...
Owner's Manual - Page 6
... system, press and hold the power button for about 6 seconds to turn them off.
After Working Inside Your Computer
After you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turning on your computer. 1. Replace the cover.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the...
Owner's Manual - Page 7
...
This section provides detailed information on how to remove or install the components from your computer.
Recommended Tools
The procedures in this document may require the following tools: • Small flat-blade screwdriver • Phillips screwdriver • Small plastic scribe
Removing the Power Supply Unit (PSU)
1. Follow the procedures in Before Working Inside...
Owner's Manual - Page 8
Installing the Power Supply Unit (PSU)
1. Hold the PSU handle and slide the PSU into the computer. 2. Follow the procedures in After Working Inside Your Computer.
Removing the Cover
1. Follow the procedures in Before Working Inside Your Computer. 2. Lay down the computer on it's right side with the latch facing up.
3. Lift up the cover-release latch.
8
Owner's Manual - Page 9
...remove it from the computer.
Installing the Cover
1. Place the computer cover on the chassis. 2. Press down on the computer cover until it clicks into place. 3. Follow the procedures in After Working Inside Your Computer.
Removing the Optical Drive
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the cover. 3. Disconnect the data and power cables from the optical drive.
9
Owner's Manual - Page 12
.... 2. Press on the clasp to release the latch and thread the cables into the holder. 3. Connect the power cable to the back of the optical drive. 4. Connect the data cable to the back of the optical drive. 5. Install the cover. 6. Follow the procedures in After Working Inside Your Computer.
Removing the Thermal Sensor
NOTE: The thermal sensor is an optional...
Owner's Manual - Page 14
.... 2. Connect the hard drive power supply cable. 3. Connect the hard drive data cable. 4. Install the cover. 5. Follow the procedures in After Working Inside Your Computer.
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) cover b) intrusion switch c) PCI card d) hard drive e) optical drive 3. Unthread the system board cable from the latch.
14
Owner's Manual - Page 19
... to the system fan. 9. Route and connect the system board cable to its connector. 10. Install:
a) optical drive b) hard drive c) PCI card d) intrusion switch e) cover 11. Follow the procedures in After Working Inside Your Computer.
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the cover. 3. Press down on the memory-securing clips on each side of the...
Owner's Manual - Page 20
... release latch springs back into place and secures it. 3. Install the cover. 4. Follow the procedures in After Working Inside Your Computer.
Removing the Heat Sink
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the cover. 3. Disconnect the heat-sink cable from the system board.
4. Loosen the screws that secure the heat sink.
20
Owner's Manual - Page 21
... and remove it from the computer.
Installing the Heat Sink
1. Place the heat sink inside the computer. 2. Tighten the captive screws to secure the heat sink to the system board. 3. Connect the heat-sink cable to the system board. 4. Install the cover. 5. Follow the procedures in After Working Inside Your Computer.
Removing the Processor
1. Follow the procedures in Before...
Owner's Manual - Page 22
... it in antistatic package.
4. Repeat the above steps to remove the second processor (if available) from the computer. To verify if your computer has dual processor slots, see the System Board Components.
Installing the Processor
1. Place the processor in its socket. 2. Replace the processor cover.
NOTE: The processor cover is secured by two levers. They have icons that indicate which...
Owner's Manual - Page 45
...Updating the BIOS
It is recommended to update your BIOS (system setup), on replacing the system board or if an update is available. For notebooks, ensure that your computer battery is fully charged and connected to a power outlet
1. Restart the computer. 2. Go to support.dell.com/support/downloads. 3. If you have your computer's Service Tag or Express Service Code:
NOTE: For desktops, the service...
Owner's Manual - Page 46
... method below window; click Download
Now. The File Download window appears. 8. Click Save to save the file on your computer. 9. Click Run to install the updated BIOS settings on your computer. Follow the instructions on the screen.
System and Setup Password
You can create a system password and a setup password to secure your computer.
Password Type Description System password Password that you...
Owner's Manual - Page 47
... cover.
NOTE: If you assign a new system and/or setup password with the PSWD jumper installed, the system disables the new password(s) the next time it boots. 6. Connect the computer to the electrical outlet and power-on the computer. 7. Power-off the computer and disconnect the power cable from the electrical outlet. 8. Remove the cover. 9. Replace the jumper on the pins...
Statement of Volatility - Page 2
... motherboard:
The Video Card contains volatile and non-volatile memory components. The volatile frame buffer memory will lose data once power is removed. The nonvolatile memory (Video BIOS) stores only video card setup information. The video BIOS is not accessible by the user.
The CD-RW/Diskette Drives/DVD-R/W/Blu Ray DVD-R/W are input/output devices, whereas the DVD-ROM is an input device...