Gigabyte GA-78LMT-USB3 driver and firmware
Drivers and firmware downloads for this Gigabyte item
Related Gigabyte GA-78LMT-USB3 Manual Pages
Download the free PDF manual for Gigabyte GA-78LMT-USB3 and other Gigabyte manuals at ManualOwl.com
Manual - Page 3
...carefully read the User's Manual. „„ For product-related information, check on our website at: http://www.gigabyte.com
Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X.X." For example, "REV: 1.0" means the revision of the motherboard is 1.0. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for...
Manual - Page 4
... Advanced BIOS Features 30 2-6 Integrated Peripherals 32 2-7 Power Management Setup 34 2-8 PnP/PCI Configurations 36 2-9 PC Health Status 36 2-10 Load Fail-Safe Defaults 37 2-11 Load Optimized Defaults 38 2-12 Set Supervisor/User Password 38 2-13 Save & Exit Setup 39 2-14 Exit Without Saving 39
Chapter 3 Drivers Installation 40 Chapter 4 Appendix...40
Configuring SATA Hard Drive(s 40...
Manual - Page 5
...
AUDIO
Realtek GbE LAN
PCIEX16
iTE Super I/O
PCIEX1 CODEC PCI
AMD 760G
IDE
SATA2
5 4
DDR3_4 DDR3_2 DDR3_3 DDR3_1
GA-78LMT-USB3
BAT Etron EJ168
F_USB30
AMD SB710
B_BIOS M_BIOS
CLR_CMOS
SATA2
2 0
3 1
F_AUDIO SPDIF_O LPT
COM F_USB2 F_USB1
F_PANEL
Box Contents 55 GA-78LMT-USB3 motherboard 55 Motherboard driver disk 55 User's Manual 55 I/O Shield
55 Two SATA cables 55 One IDE cable...
Manual - Page 8
... GIGABYTE's website for the latest supported memory speeds and memory
modules.)
Onboard
ŠŠ North Bridge:
Graphics
- 1 x D-Sub port - 1 x DVI-D port, supporting a maximum resolution of 1920x1200
* The DVI-D port does not support D-Sub connection by adapter.
- 1 x HDMI port, supporting a maximum resolution of 1920x1200 * Simultaneous output for DVI-D and HDMI is not supported.
Audio...
Manual - Page 9
...8-pin ATX 12V power connector ŠŠ 6 x SATA 3Gb/s connectors ŠŠ 1 x IDE connector ŠŠ 1 x CPU fan header ŠŠ 1 x system fan header ŠŠ 1 x front panel header ŠŠ 1 x front panel audio header ŠŠ 1 x S/PDIF Out header ŠŠ 1 x USB 3.0/2.0 header ŠŠ 2 x USB 2.0/1.1 headers ŠŠ 1 x serial port header ŠŠ...
Manual - Page 10
... Features" and "Bundled Software" columns.
1-3 Installing the CPU
Read the following guidelines before you begin to install the CPU: •• Make sure that the motherboard supports the CPU.
(Go to GIGABYTE's website for the latest CPU support list.) •• Always turn off the computer and unplug the power cord from the power outlet before installing the
CPU to prevent hardware...
Manual - Page 12
...>Sound>Playback, set Realtek HDMI Output - ATI HDMI Audio to the default playback device.
(Note 1) The DVI-D port does not support D-Sub connection by adapter. (Note 2) Simultaneous output for DVI-D and HDMI is not supported.
•• When removing the cable connected to a back panel connector, first remove the cable from your device and then remove it from the motherboard.
••...
Manual - Page 13
...Hardware Acceleration is
enabled.) •• HDCP compliant monitor(s)
USB 3.0/2.0 Port The USB 3.0 port supports the USB 3.0 specification and is compatible to the USB 2.0/1.1 specification. Use this port for USB devices such as a USB keyboard/mouse, USB printer, USB flash drive and etc.
RJ-45 LAN Port The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The...
Manual - Page 23
... the BIOS Setup program, press the key during the POST when the power is turned on. To upgrade the BIOS, use either the GIGABYTE Q-Flash or @BIOS utility. •• Q-Flash allows the user to quickly and easily upgrade or back up BIOS without entering the operating system. •• @BIOS is a Windows-based utility that searches and downloads the latest version of BIOS from the Internet...
Manual - Page 25
2-3 MB Intelligent Tweaker(M.I.T.)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software MB Intelligent Tweaker(M.I.T.)
` IGX Configuration CPU Clock Ratio CPU NorthBridge Freq. Core Performance Boost (Note) CPB Ratio (Note) Turbo CPB (Note) CPU Host Clock Control
x CPU Frequency(MHz) PCIE Clock(MHz) HT Link Width HT Link Frequency Set Memory Clock
x Memory Clock ` DRAM Confi...
Manual - Page 29
... POST for faster system startup. •• Auto Lets the BIOS automatically detect IDE/SATA devices during the POST. (Default) •• Manual Allows you to manually enter the specifications of the hard drive when the hard drive access mode is set to CHS. Access Mode Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large.
&& IDE...
Manual - Page 30
..."All Errors," "No Errors," "All, But Keyboard". (Default)
&& Memory These fields are read-only and are determined by the BIOS POST.
2-5 Advanced BIOS Features
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software Advanced BIOS Features
` IGX Configuration Load Line Control AMD C1E Support Virtualization AMD K8 Cool&Quiet control CPU Unlock (ൗ) CPU core Control
x CPU core 0 x CPU...
Manual - Page 31
... lets the BIOS automatically configure this setting depending on the hard drive you install. (Default: Auto)
&& First/Second/Third Boot Device Specifies the boot order from the available devices. Use the up or down arrow key to select a device and press to accept. Options are: LS120, Hard Disk, CDROM, ZIP, USB-FDD, USB-ZIP, USB-CDROM, USB-HDD, Legacy LAN, Disabled.
&& Password Check Specifies...
Manual - Page 32
...Sets the PCI Express graphics card on the PCIEX16 slot as the first display.
2-6 Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software Integrated Peripherals
OnChip SATA Controller OnChip SATA Type x OnChip SATA Port4/5 Type x OnChip SATA Port as ESP Onboard LAN Function Onboard LAN Boot ROM ` SMART LAN Onboard Audio Function F_USB30 Controller R_USB30 Controller USB...
Manual - Page 33
...you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled.
&& Onboard LAN Boot ROM Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled)
&& SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software SMART LAN
Start detecting at Port.....
Part1...
Manual - Page 34
... Parallel Port Mode is set to ECP or ECP+EPP. Options are: 3 (default), 1.
2-7 Power Management Setup
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software Power Management Setup
ACPI Suspend Type Soft-Off by Power button USB Wake Up from S3 Modem Ring Resume PME Event Wake Up HPET Support (Note) Power On By Mouse Power On By Keyboard x KB Power ON Password AC Back Function Power-On...
Manual - Page 35
... state by a wake-up signal from a PCI or PCIe device. Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead. (Default: Enabled)
&& HPET Support (Note) Enables or disables High Precision Event Timer (HPET) for Windows 7/Vista operating system. (Default: Enabled)
&& Power On By Mouse Allows the system to...
Manual - Page 38
... updating the BIOS or after clearing the CMOS values.
2-12 Set Supervisor/User Password
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
` MB Intelligent Tweaker(M.I.T.) ` Standard CMOS Features ` Advanced BIOS Features ` Integrated Peripherals ` Power Management Setup ` PnP/PCI Configurations Enter Password: ` PC Health Status
Load Fail-Safe Defaults Load Optimized Defaults Set...
Manual - Page 40
...7/Vista/XP setup disk. •• Motherboard driver disk. •• A USB floppy disk drive (needed during Windows XP installation) •• An empty formatted floppy disk (needed during Windows XP installation)
Configuring the Onboard SATA Controller A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the...
Manual - Page 42
... a USB floppy disk drive to your computer first because you need to install the SATA RAID/AHCI driver from a floppy disk that contains the driver during the OS installation. To copy the RAID/AHCI driver for Windows XP, copy all files in the \BootDrv\SBxxx\x86 folder in the motherboard driver disk to your floppy disk. To install Windows 64-Bit, copy the files in the x64 folder.
Installing the SATA...