HP DL560 - ProLiant - 1 GB RAM driver and firmware
Drivers and firmware downloads for this Hewlett-Packard item
Related HP DL560 Manual Pages
Download the free PDF manual for HP DL560 and other HP manuals at ManualOwl.com
HP USB Floppy Drive Key Installation Instructions - Page 2
...how to disconnect the drive key.
Downloading user documentation and drivers
DOWNLOAD INFORMATION To download the latest user documentation and drivers:
1. Go to www.hp.com.
2. Click Support and Troubleshooting Information from the left menu bar.
3. Type the product name in the product field and press Enter.
4. Click Manuals from the Resources section or Download Drivers and Software from the Tasks...
ProLiant Essentials Foundation Pack Installation Guide - Page 1
...8226; Download the latest individual software components from the Software and Driver download pages available from www.hp.com/support
• Use HP SIM and Version Control to automatically download the latest versions of ProLiant software, identify servers running out-of-date software, and deploy updates to groups of systems running Windows or Linux.
• Download or buy a ProLiant Essentials...
Dynamic Power Capping TCO and Best Practices White Paper (EMEA edition) - Page 9
Dynamic Power Caps should always be done in conjunction with your facilities department.
• First, download and apply the following updates to your HP ProLiant server (see Appendix for list of supported servers):
Table 4. Component Requirement for Rack-Mount Servers
Required Component
ROM BIOS
iLO IPM component of Insight Control Environment
Version Required
11/1/2008 or later
1.70 or ...
Regular Firmware Updates Essential for Optimal Performance and Functionality of HP ProLiant Servers - Page 3
....) The Critical Component Update is also logged in the Windows NT Event Log and the HP SIM Console.
The examples below show how easy and convenient it is to check for (and install) updates using the System Management Homepage. The Version Control Agent indicates (by displaying an exclamation point inside a yellow triangle) that an updated version of software is available (but...
Regular Firmware Updates Essential for Optimal Performance and Functionality of HP ProLiant Servers - Page 8
...=c01039146
A ROMPaq is a floppy-disk based method of upgrade. The firmware is downloaded onto a floppy diskette and then the system is booted to the floppy drive.
The ROM Update Utility is located on the Firmware Maintenance CD, or can be downloaded to a USB Drive Key using the HP Drive Key Boot Utility.
Note: Hard Drive components can only be updated using the Offline method.
Back...
HP ProLiant Servers Troubleshooting Guide - Page 5
... Support software 76 Keeping the system current ...77 Drivers ...77 ProLiant Support Packs ...77 Version control ...77 Operating system version support ...77 HP Smart Update Manager...77 System Online ROM flash component utility 78 Subscriber's choice...78 Care Pack ...78 Firmware maintenance...79 Types of ROM...79 Verifying firmware versions...80 Updating firmware ...81 Unsupported processor...
HP ProLiant Servers Troubleshooting Guide - Page 72
... Pack is included on the Insight Control Data Center Edition DVD. For more information, see the HP ProLiant Essentials Vulnerability and Patch Management Pack User Guide, or the HP website (http://www.hp.com).
HP Insight Server Migration software for ProLiant
The HP Insight Server Migration software for ProLiant (SMP) enables administrators to upgrade or replace an existing server through...
HP ProLiant Servers Troubleshooting Guide - Page 77
... as well as other option drivers, ROM images, and value-add software can be downloaded from the HP website (http://www.hp.com/support).
ProLiant Support Packs
PSPs represent operating system-specific bundles of ProLiant optimized drivers, utilities, and management agents. Refer to the PSP website (http://h18000.www1.hp.com/products/servers/management/psp.html).
Version control
The VCRM and VCA are...
HP ProLiant Servers Troubleshooting Guide - Page 94
... to configure the NVRAM.
Controller Firmware Needs Upgrading
Description: Controller firmware is below the latest recommended version. Action: Update the controller to the latest firmware version ("Firmware maintenance" on page 79).
Controller is Located in Special "Video" Slot
Description: Controller is installed in the slot for special video control signals. If the controller is used in this...
HP ProLiant Servers Troubleshooting Guide - Page 95
... of an operating system device driver. Action: Restart the system. Run ACU ("Array Configuration Utility" on page 67) to reinitialize the array accelerator board.
Drive (Bay) X Firmware Needs Upgrading
Description: Firmware on this physical drive is below the latest recommended version. Action: Update the drive to the latest firmware version ("Firmware maintenance" on page 79).
Drive (Bay) X has...
HP ProLiant Servers Troubleshooting Guide - Page 123
...following error may appear:
Error - USB tape drive not in Disaster Recovery mode. 3. Follow the onscreen directions:
Remove power to USB drive and reboot. The following message should appear: OBDR is now enabled for the attached USB tape drive.
WARNING: A Type 2 Header PCI Device Has Been Detected...
The BIOS will not configure this card. It must be configured properly by the OS or driver.
Audible...
Implementing Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 20
... Array Cluster Controller Firmware Version 1.70 (or later) and upgrade to Version 5.42.2.32 (or later) of the CPQCISSE.SYS driver.
Smart Array Cluster Controller Firmware Version 1.70 (or later) is downloadable as follows:
• Name: Online ROM Flash Component for Windows - Compaq Smart Array Cluster Storage Controller
• Download location: http://h18007.www1.hp.com/support/files/server...
Integrating Microsoft Windows Server 2003 R2 on HP ProLiant servers - Page 13
... drivers for the supported devices may not be included on the base media.
NOTE These changes are only necessary when using an UNATTEND.TXT file with the OEMPreinstall flag set. Failure to set this flag could cause installs to abort with the following message: "File [filename] could not be loaded. Error code is 18. Setup cannot continue."
Part 2: Install Windows Server...
Implementing Novell NetWare 6.5 on ProLiant servers integration note - Page 27
... using Remote Console or Virtual Media, upgrade to iLO 2 Firmware Version 1.01 AND NetWare 6.5 SP5, which are available at the following URLs:
• iLO 2 Firmware Version 1.01 (or later)
To download, go to www.hp.com/support and select the country and language.
• Select the Download drivers and software (and firmware) radio button.
• Type the name of the server in the window...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 5
...
http://h18023.www1.hp.com/support/ files/server/us/romtabl.html
… HP Smart Array Multipath Software Version 2.0
For customers with multipath hardware
www.hp.com/products/sharedstorage
… HP Windows Server 2003 For the latest
website
information
http://h71028.www7.hp.com/enterprise/ cache/8193-0-0-0-121.aspx
… Internet access
For system updates
… Minimum requirements...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 6
... any questions regarding this utility. 5. Execute PRIMER.EXE to run this utility. Then, reboot the server. 6. Use the ROM-Based Setup Utility (RBSU) or the System Configuration Utility to set the OS to Microsoft Windows 2000/Windows Server 2003. 7. Choose either of the following installation paths and proceed to the associated section to complete the upgrade: • Manual install •...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 8
... to the upgrade. 3. Download and install ProLiant Support Pack for Microsoft Windows 2000 Version 7.30A from the software and drivers website at http://h18023.www1.hp.com/support/files/server/us/locate/1989.html. This action ensures that all drivers and utilities provided by HP are suitable for upgrading to Windows Server 2003.
IMPORTANT: Failure to update drivers provided by HP before beginning...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 9
...
After completing the tasks identified in the prerequisites section, continue the upgrade, as follows, to perform a manual install: 1. Insert the Windows Server 2003 with Service Pack 1 CD into CD-ROM drive to begin installation.
Follow all instructions for upgrading the server. 2. When prompted, choose to download updated setup files from Microsoft.
You will then get two yellow bangs (which...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 12
... Software Version 1.0 prior to the OS upgrade. Once the Windows Server 2003 upgrade and the ProLiant Support Pack installation are complete, install HP Smart Array Multipath Software Version 2.0 (or later).
Software fault tolerant volumes (dynamic disks) fail during driver upgrade or rollback.
Description
When a device driver is updated for a device containing dynamic disks, the software...
Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note - Page 14
...less remaining in the upgrade process. This is caused by Windows stopping and restarting this driver during the upgrade.
If Version 5.33.2195.0 or earlier of the CPQASM2.SYS driver is installed, the following Authenticode security alert will be displayed:
Security Alert Driver Installation
The driver software you are installing for HP ProLiant iLO Advanced System Management Controller has not been...