Seagate Barracuda Green driver and firmware
Drivers and firmware downloads for this Seagate item
Related Seagate Barracuda Green Manual Pages
Download the free PDF manual for Seagate Barracuda Green and other Seagate manuals at ManualOwl.com
Product Manual - Page 9
.../slave environment to host software where two devices on separate Serial ATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical Serial ATA environment.
Barracuda Green SATA Product Manual, Rev. A
9
Product Manual - Page 10
The Serial ATA host adapter and drive share the function of emulating parallel ATA device behavior to provide backward compatibility with existing host systems and software. The Command and Control Block registers, PIO and DMA data transfers, resets, and interrupts are all emulated.The Serial ATA host adapter contains a set of registers that shadow the contents of the traditional device registers,...
Product Manual - Page 20
...support.seagate.com/customer/warranty_validation.jsp From this page, click on the "Verify Your Warranty" link. You will be asked to provide the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for your drive... by EN55022, Class B and the immunity levels are defined by EN55024.
20
Barracuda Green SATA Product Manual, Rev. A
Product Manual - Page 21
....
Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception.
Radio and television...
Product Manual - Page 22
.... The following table contains information mandated by China's "Marking Requirements for Control of Pollution Caused by Electronic Information Products" Standard.
"O" indicates the hazardous... as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are ...Barracuda Green SATA Product Manual, Rev. A
Product Manual - Page 23
... they are Device 0 (master) devices. Serial ATA drives are designed for easy installation. It is usually not necessary to set any jumpers on the drive for proper operation; however, if you connect the drive and receive a "drive not detected" error, your SATA-equipped motherboard or host adapter may use a chipset that does not support SATA speed autonegotiation.
3.3 Serial ATA cables and connectors...
Product Manual - Page 25
...on the Serial ATA interface and power connectors.
Table 5 Serial ATA connector pin definitions
Segment Pin Function
Definition
S1 Ground S2 A+
2nd mate Differential signal pair A from PHY
S3 A-
Signal
S4 Ground
2nd mate
S5 B-
Differential signal pair B from PHY
S6 B+ S7 Ground
2nd mate
Key and spacing separate signal and power segments
Barracuda Green SATA Product Manual, Rev. A
25
Product Manual - Page 26
...to the Serial ATA International Organization: Serial ATA Revision 3.0 (http://www.sata-io.org).
See "S.M.A.R.T. commands" on page 34 for details and subcommands used in the S.M.A.R.T. implementation.
Table 6 Supported ATA commands
Command name
Command code (in hex)
Check Power Mode Device Configuration Freeze Lock Device Configuration Identify
E5H B1H / C1H B1H / C2H
26
Barracuda Green SATA...
Product Manual - Page 27
... Read Verify Sectors Extended Read Verify Sectors Without Retries Recalibrate Security Disable Password Security Erase Prepare
B1H / C0H B1H / C3H 08H 92H 90H E7H EAH 50H ECH E3H E1H 91H E4H C8H 25H C9H 2FH C4H 29H F8H 27H 20H 24H 21H 40H 42H 41H 10H F6H F3H
Barracuda Green SATA Product Manual, Rev. A
27
Product Manual - Page 29
... 0000H 0400H 0000H x.xx
27-46
47 48 49
Drive model number: (40 ASCII characters, padded with blanks to end of string)
ST2000DL003 ST1500DL003
(Bits 7-0) Maximum sectors per interrupt on Read multiple and Write multiple (16)
8010H
Reserved
0000H
Standard Standby timer, IORDY supported and may be disabled 2F00H
Barracuda Green SATA Product Manual, Rev. A
29
Product Manual - Page 33
www.seagate.com
Serial ATA Interface
Table 8 Bit Descriptions (Continued)
14
Ultra DMA mode 6 is currently active.
4.3.2 Set Features command
This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If the value in the register...
Product Manual - Page 34
... ATA-5 Standard.
SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4H) that eliminates unnecessary drive returns. The diagnostic software ships with all new drives and is also available at: http://seatools.seagate.com.
This drive is shipped with S.M.A.R.T. features disabled. You must have a recent BIOS or software package that supports S.M.A.R.T. to...