Seagate ST250LT003 driver and firmware
Related Seagate ST250LT003 Manual Pages
Download the free PDF manual for Seagate ST250LT003 and other Seagate manuals at ManualOwl.com
Momentus Thin (.2-4K) SATA Product Manual - Page 8
... of Seagate Self-Encrypting Drive models were called Full Disk Encryption (FDE) models before a differentiation between drive-based encryption and other forms of encryption was necessary.
Note. The Self-Encrypting Drive models indicated on the cover of this product manual have provisions for "Security of Data at Rest" based on the standards defined by the Trusted Computing...
Momentus Thin (.2-4K) SATA Product Manual - Page 9
... environment to host software where two devices on separate Serial ATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical Serial ATA environment.
The Serial ATA host adapter and drive share the function...
Momentus Thin (.2-4K) SATA Product Manual - Page 11
...operating (Swept Sine) Vibration, nonoperating Drive acoustics, sound power (bels)
Idle**
Seek
Nonrecoverable read errors Annualized Failure Rate (AFR) Load/Unload (U/UL) cycles
ST320LT007 - 9ZV142...
Supports Hotplug operation per Serial ATA Revision 2.6 specification
600,000 software-controlled power on/off cycles 20,000 hard power on/off cycles
To determine the warranty for a specific drive,...
Momentus Thin (.2-4K) SATA Product Manual - Page 20
... inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
*Defined as the median curve given by ISO 389-7 (Tf curve) minus 10dB at all frequencies.
3.12
Electromagnetic immunity
When properly installed in a representative host system, the drive operates without errors or degradation in performance when...
Momentus Thin (.2-4K) SATA Product Manual - Page 21
3.13
Reliability
Measurement type Nonrecoverable read errors Annualized Failure Rate (AFR) Load/Unload (U/UL)
25°C, 50% relative humidity
32°C, 80% relative humidity 5°C, 80% relative humidity 5°C, 10% relative humidity 55°C, 16% relative humidity Warranty
Specification 1 per 1014 bits read, max
Momentus Thin (.2-4K) SATA Product Manual - Page 22
... required.
Seagate Technology LLC has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception...
Momentus Thin (.2-4K) SATA Product Manual - Page 23
...years. The following table contains information mandated by China's "Marking Requirements for Control of Pollution Caused by Electronic Information Products" Standard.
"O" indicates the hazardous ...chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are ...Manual, Gen-2 Rev. D
17
Momentus Thin (.2-4K) SATA Product Manual - Page 24
... one Serial ATA host adapter, the host operating system views the two devices as if they were both "masters" on two separate ports. This means both drives behave as if they are Device 0 (master) devices.
Serial ATA drives are designed for easy installation. It is normally not necessary to set any jumpers on this drive for proper operation. If the host system does not support SATA...
Momentus Thin (.2-4K) SATA Product Manual - Page 25
... to be hot pluggable and blind mateable.
For installations which require cables, you can connect the drive as illustrated in Figure 3.
SATA interface connector Power connector
SATA interface cable
Power cable
Figure 3. Attaching SATA cabling Each connector is keyed to ensure correct orientation.
4.4
Drive mounting
You can mount the drive using four screws in the side-mounting holes or...
Momentus Thin (.2-4K) SATA Product Manual - Page 28
... computer security standard used to accredit cryptographic modules. It is titled "Security Requirements for Cryptographic Modules". The initial publication was on May 25, 2001 and was last updated ... that include both hardware and software components.
Federal Information Processing Standard (FIPS) 140-2 Level 2 Certification requires drives to go through government agencies ...Manual, Gen-2 Rev. D
Momentus Thin (.2-4K) SATA Product Manual - Page 30
...drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from http://www.serialata.org. This device requires a COMRESET from the host after a hotplug event.
6.2
Serial ATA device plug connector pin definitions
Table 7 summarizes the signals on the Serial ATA interface and power connectors.
Table 7: Serial ATA...
Momentus Thin (.2-4K) SATA Product Manual - Page 31
...Serial ATA connector pin definitions
Segment Pin P1 P2 P3 P4 P5 P6 P7 P8
Power P9 P10 P11
P12 P13 P14 P15
Function V33 V33 V33 Ground Ground Ground V5 V5 V5 Ground Reserved
Ground V12 V12 V12
Definition 3.3V power 3.3V power 3.3V power...mated with P11 in the power cable receptacle connector shall always be grounded 1st mate. 12V power, pre-charge, 2nd mate 12V power 12V power
Notes: 1. All pins ...
Momentus Thin (.2-4K) SATA Product Manual - Page 32
...to the Serial ATA: High Speed Serialized AT Attachment specification. See "S.M.A.R.T. commands" on page 33.for details and subcommands used in the S.M.A.R.T. implementation.
Command name
Command code (in hex)
ATA-standard commands
Device Configuration Restore
B1h/C0h
Device Configuration Freeze Lock
B1h/C1h
Device Configuration Identify
B1h/C2h
Device Configuration Set
B1h/C3h
Download...
Momentus Thin (.2-4K) SATA Product Manual - Page 34
... • Bit 6: removable controller • Bit 0: reserved Number of logical cylinders ATA-reserved Number of logical heads Retired Retired Number of logical sectors per logical track: 63 Retired Serial number: (20 ASCII characters, 0000H = none) Retired Retired Obsolete Firmware revision (8 ASCII character string, padded with blanks to end of string)
Drive model number: (40 ASCII...
Momentus Thin (.2-4K) SATA Product Manual - Page 38
...
This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an interrupt. If the value in the register does not represent a feature that the drive supports, the command is aborted. Power-on default has the read...
Momentus Thin (.2-4K) SATA Product Manual - Page 39
... ATA-8 Standard.
SeaTools diagnostic software activates a built-in drive self-test (DST S.M.A.R.T. command for D4H) that eliminates unnecessary drive returns. The diagnostic software ships with all new drives and is also available at:
http://seatools.seagate.com.
This drive is shipped with S.M.A.R.T. features disabled. You must have a recent BIOS or software package that supports S.M.A.R.T. to...
Momentus Thin (.2-4K) SATA Product Manual - Page 41
...B computing device 16 compatibility 15 Conducted noise 10 Conducted RF immunity 14 Configuring the drive 18 connectors 19 CSA60950-1 15 current 4 cycles 15 Cylinders 6
D
data-transfer rates 2 DC power 8 Default logical geometry 6 density 4 Device Configuration Freeze Lock 26 Device Configuration Restore 26 Device Configuration Set 26 Diagnostics 26
dimensions 20, 21
Disks 4 dissipation 8 Download...
Momentus Thin SATA Product Manual - Page 9
... environment to host software where two devices on separate Serial ATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical Serial ATA environment.
The Serial ATA host adapter and drive share the function...
Momentus Thin (4K) SATA Product Manual - Page 9
... environment to host software where two devices on separate Serial ATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical Serial ATA environment.
The Serial ATA host adapter and drive share the function...
Momentus Thin SATA Product Manual - Page 8
... environment to host software where two devices on separate Serial ATA ports are represented to host software as a Device 0 (master) and Device 1 (slave) accessed at the same set of host bus addresses. A host adapter that emulates a master/slave environment manages two sets of shadow registers. This is not a typical Serial ATA environment.
The Serial ATA host adapter and drive share the function...