Sony FCBEX480CP driver and firmware
Related Sony FCBEX480CP Manual Pages
Download the free PDF manual for Sony FCBEX480CP and other Sony manuals at ManualOwl.com
Specification Sheet (specsheet_fcbfamily) - Page 4
.... Non-metric weights and measurements are approximate. Sony, Exwave HAD, Advanced HAD, EXview HAD, i.LINK, Steady Shot, Memory Stick and Super HAD are trademarks of Sony. FireWire is a registered trademark of Apple Computer, Inc.
FOR FCB AND EVI CAMERAS, The RS-232 Control Protocol and command list is provided by Sony on an "as-is basis" without...
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 4
...
Use of the demonstration software developed by Sony Corporation or use of the software with customer developed application software may damage hardware, the application program or the camera. Sony Corporation is not liable for any damages under these conditions.
Operation
Start the camera control software on your computer after you turn on the camera and the image is displayed.
Other
Do not...
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 7
... display and other features are turned off.
• I/F clear Clears the Command buffer of the FCB camera. Clearing the buffer can also be carried out from the control application software when the power is on.
• Address set VISCA is a protocol, which normally can support a daisy chain of up to seven attached devices. However, the FCB camera does not support camera connections...
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 9
...which can be set using VISCA Commands.
• Auto White Balance This mode computes the white ...camera. One Push White Balance data is lost when the power is turned off. If the power is turned off, reset the One Push White Balance.
• Manual WB Manual control... set, the speed can be 1/30, 1/15, 1/8, or 1/4 s. The picture output is read at a normal rate from the memory. The memory is updated ...
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 14
... simultaneously.
• Privacy Zones are displayed according to priority in alphabetical order.
• Individual on/off zone masking settings. • Two colors from among 28 colors can be individually
set for each of 24 privacy zones. • Interlocking control with zooming. • Interlocking control with Pan/Tilt. • Non-interlocking control with Pan/Tilt.
Timing chart...
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 21
Mode "01"
Alarm On AE moves.
Basic Functions
Focus Position into memory Hysteresis is set to the factory preset.
Focus moves outside of the hysteresis.
*
High level signal output
* Repeat this loop until Alarm off.
AE does not move for a period of time.
AE does not move for a period of time.
Low level signal output Update the Focus position data.
21
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 23
Mode "03"
Alarm On
AE moves.
AE moves outside of the hysteresis.
High level signal output * * Repeat this loop until Alarm off.
AE does not move for a period of time.
Low level signal output Update the AE level data
Basic Functions
AE level into memory Hysteresis is set to the factory preset.
AE does not move for a period of time.
23
User Manual (FCB-EX480C_EX48C_Technical Manual) - Page 39
... HARDWARE AND SOFTWARE USED WITH IT (INCLUDING SONY HARDWARE AND SOFTWARE) AND SPECIFICALLY DISCLAIMS ANY LIABILITY FOR ANY SUCH MALFUNCTION OR DAMAGE. THIS CONTROL PROTOCOL AND COMMAND LIST SHOULD BE USED WITH CAUTION.
Overview of VISCA
In VISCA the device outputting commands, for example, a computer, is called the controller. The device receiving the commands, an FCB camera is called...