Sony FCBIX45C driver and firmware
Related Sony FCBIX45C Manual Pages
Download the free PDF manual for Sony FCBIX45C and other Sony manuals at ManualOwl.com
Product Manual (Color Camera Module - Technical Manual) - Page 5
... Commands; the display and other features are turned off.
• I/F clear Clears the Command buffer of the FCB camera. Clearing the buffer can also be carried out from the control application software when the power is on.
• Address set VISCA is a protocol, which normally can support a daisy chain of up to seven attached devices. Therefore, whenever a camera is connected...
Product Manual (Color Camera Module - Technical Manual) - Page 7
...set using VISCA Commands.
• Auto White Balance This mode computes...camera. One Push White Balance data is lost when the power is turned off. If the power is turned off, reset the One Push White Balance.
• Manual WB Manual control...set, the speed can be 1/30, 1/15, 1/8, or 1/4 s. The picture output is read at a normal rate from the memory. The memory is updated... is not supported by the FCB...
Product Manual (Color Camera Module - Technical Manual) - Page 11
... simultaneously.
• Privacy Zones are displayed according to priority in alphabetical order.
• Individual on/off zone masking settings. • Two colors from among 28 colors can be individually
set for each of 24 privacy zones. • Interlocking control with zooming. • Interlocking control with Pan/Tilt. • Non-interlocking control with Pan/Tilt.
Timing chart...
Product Manual (Color Camera Module - Technical Manual) - Page 18
Mode "01"
Alarm On AE moves.
Basic Functions
Focus Position into memory Hysteresis is set to the factory preset.
Focus moves outside of the hysteresis.
*
High level signal output
* Repeat this loop until Alarm off.
AE does not move for a period of time.
AE does not move for a period of time.
Low level signal output Update the Focus position data.
18
Product Manual (Color Camera Module - Technical Manual) - Page 20
Mode "03"
Alarm On
AE moves.
AE moves outside of the hysteresis.
High level signal output * * Repeat this loop until Alarm off.
AE does not move for a period of time.
Low level signal output Update the AE level data
Basic Functions
AE level into memory Hysteresis is set to the factory preset.
AE does not move for a period of time.
20
Product Manual (Color Camera Module - Technical Manual) - Page 36
...The devices on the network are assigned addresses. The address of the controller is fixed at 0. The addresses of the peripheral devices are 1, 2, 3 ... in order, starting from the one nearest the conttoller. The address of the peripheral device is set by sending address commands during the initialization of the network.
...1)VISCA is a protocol which controls consumer camcorders developed by Sony...
Product Manual (Color Camera Module - Technical Manual) - Page 58
...
Use of the demonstration software developed by Sony Corporation or use of the software with customer developed application software may damage hardware, the application program or the camera. Sony Corporation is not liable for any damages under these conditions.
Operation
Start the camera control software on your computer after you turn on the camera and the image is displayed.
Other
Do not...