Sony MDP-1000 driver and firmware
Related Sony MDP-1000 Manual Pages
Download the free PDF manual for Sony MDP-1000 and other Sony manuals at ManualOwl.com
Operating Instructions - Page 2
... (servicing) instructions in the literature accompanying the appliance.
INFORMATION This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturers instructions. may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device...
Operating Instructions - Page 4
...safety and iviN lit into the power outlet only
one way. If you are unable to insert the plug fully into the
outlet, contact your dealer. On Installation
• Avoid placing the player in a location subject to:...set with a disc in place. • When the disc tray is in the open position, do not press down on it strongly, or place heavy objects on On cleaning Clean the cabinet panel and controls...
Operating Instructions - Page 6
...
Front panel_
Disc tray 0, • Remote control sensor
*, POWER switch
Mee*
9.190•1048 •
310
r
PHONES (headphones) jack (stereo phone plug) and LEVEL control • •
AUTO REPEAT button •, • Press to repeat the entire disc side.
Display window
14 ",,Ass. The shipping box should contain the following accessories.
RMT-333A Remote Commander
Two eke AA (Re...
Operating Instructions - Page 18
... in the display window on the player.
Or to display them on the week press the DISPLAY button on the Remote Commander.
beginning... of the previous chapter.
Press We $14 button to advance to the beginning of the next chapter.
To enter a number greater than 10 Use the +10 and 0 buttons.
Example: io...
Operating Instructions - Page 19
...more to retwn the display indication to zero, and then enter the correct numbers as
follows.
For CAV-five digits For CLV with seconds- fow digits Far CLV without seconds-two digits
•
4
i...current frame/tins numbers These numbers appear in the display window on the player. Or to display them on the screen, press the DISPLAY button on the Remote Commander.
%ARCA /NEXT
Playback starts at the ...
Operating Instructions - Page 20
... - must be pressed to cancel the repeat function.)
To check the current status Check the indicators ki the display window on the player. Or to display them on the screen, Press the DISPLAY button on the Remote Commander.
To use custom repast To repeat playback between two predefined points on the disc, refer to page 0.
AUTO...
Operating Instructions - Page 21
...the PGM button.
PQM PA3CPWA4L4I is«
PGM indication Nghts in the player's display window.
2 Press the Number buttons 5 4 2 6.
To release or cancel...removed or the power is switched off.
LD with TOO Data When you program for an LD with TOC data, the blowing display is shown. ...to back
up) buttons until the incorrect
number on the screen flashes
*ARCH
SACK
13
a
Then enter a new number.
To ...
Operating Instructions - Page 27
...and time infonnatIon an the screen Turn on the power of the TV or monitor. Time and track for the CO...button.
I Press the PGM button.
PGM indication lights in the player's display window.
2 Press the Number buttons(EllEl
c0-n.ne!)
If you male...SACK (to back
up) buttons until the incorrect
n n number on the screen flashes.
SEARCH /NEXT
SACK
or
Then enter a new number.
To enter track timbers ...
Operating Instructions - Page 28
... pause. Auto Program contents Program contents we stored until the disc is removed or the power is turned off. N your disc contains more than 20 selections Selection with minters over 20... not be run if your selection is
S larger Men the designated playing time.
OM
PGM lAnks in the player display window. •
29 Designate the time length for a single
side of your tape.
Example: For 30 minutes...
Operating Instructions - Page 29
.... •• For COV discs, these figures refer only to the current
portion (audio/video) displayed.
Display on TV sorwon If the TV set or monitor connected to the player is on and the DISPLAY button is pressed, the track minter. time. and other intimation recorded on the CO/COV St appear on
background on Me monitor.
Note on...
Operating Instructions - Page 33
...Index stored? The custom index data are not actuary recorded on the dec but stored in the memory of the player. Therefore, the custom index points set with one player cannot be used when the disc is played on ... points once
Press the 1/ALL button, so that the indication SINGLE is shown on the display window. Then perform custom index search to the desired index start point. The section between this ...
Operating Instructions - Page 34
...When a LD without TOC data, the indication "NO TOC"
appears on the display window, and shuffle playback cannot be conducted.
To skip to the next selection during ... is not possible.
Shuffle playback with COY discs Selections from the audio portion and video portion we played in random order.
SHUFFLE button ...display has stopped flashing. The selections on the disc can be played back in a random...
Operating Instructions - Page 35
...SEARCH/NEXT (to
advance) or BACK (to back
up) buttons until the incorrect
number on the screen
flashes.
SEAFCH
/NW
BACK
!.) or ! rep
3 Press the I> button.
PLAY
Then enter a new number...button on the Remote Commander to activate the REPEAT indication on the display window. When the unit is turned off or the disc is removed, shuffle functions we cancelled.
The player automatically selects ...
Operating Instructions - Page 38
... or anti-static spray intended for analog record din
After playing, remove the disc and... longer than its predecessor.
Digital sound disc
Some Los include a high-quality digital audio signal as well
as ...with priority placed on the digital audio signal.
. Chapter number
...-s) - Among various 1.0 software, there are discs with TOC (Table of Contents) signals recorded. When playing back LDs ...
Operating Instructions - Page 39
... and LD/CD Indication in display window flashes.
Point to check
• Power cord properly plugged into AC outlet?
• Unit correctly plugged in? • Disc inserted? • Disc properly seated? • Recorded side facing upward?
• TV or monitor switched out? • TV properly connected to player? • Input selector of TV, TV tuner, or monitor set to required position...