Acer CB241H driver and firmware
Related Acer CB241H Manual Pages
Download the free PDF manual for Acer CB241H and other Acer manuals at ManualOwl.com
User Manual - Page 4
...never be placed near or over a radiator or heat register, or in a built-in installation unless proper ventilation is provided.
• Never push objects of any kind into this product ... devices.
"For displays with glossy bezels the user should consider the placement of the display as the bezel may cause disturbing reflections from surrounding light and bright surfaces."
Using electrical power
...
User Manual - Page 9
...reflections by: • placing your display in such a way that the side faces the window or
any light source
• ...display's top front edge
• Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended
periods of time.
Developing good work habits
Develop the following work habits to make your computer...
User Manual - Page 12
... Communications Commission Declaration of Conformity Unpacking Attaching/removing the base Screen position adjustment Connecting the power cord Power saving Display Data Channel (DDC) Connector pin assignment Standard timing table Installation User controls How to adjust a setting Acer eColor Management User Troubleshooting HDMI mode DVI mode DP mode
1
iii iii iii iii iii iv iv iv iv v vi vi vii...
User Manual - Page 14
English
2
ATTACHING/REMOVING THE BASE
Install: Align the base with the stand and push the base towards the top of the monitor, and then rotate the base clockwise. Tighten the screw clockwise.
Remove: Reverse the steps to remove the base.
User Manual - Page 17
...-colored power LED.
Mode On
Power saving
LED light Blue
Amber
The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the...
User Manual - Page 22
... and the other end to the computer's port.
f HDMI Cable (Only HDMI or MHL Input Model) a. Make sure both the monitor and computer are powered-OFF. b. Connect the HDMI or MHL cable to the computer.
2 Connect the power cord Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Optional:Connect the audio input socket(AUDIO IN) of the LCD monitor...