Acer EB321HQU driver and firmware
Drivers and firmware downloads for this Acer Computers item
Related Acer EB321HQU Manual Pages
Download the free PDF manual for Acer EB321HQU and other Acer manuals at ManualOwl.com
User Manual - Page 4
... fuse rating.
• Do not overload a power outlet, strip or receptacle by plugging in too many devices. The overall system load must not exceed 80% of the branch circuit rating. If power strips are used, the load should not exceed 80% of the power strip's input rating.
• This product's power cord is equipped with a three-wire...
User Manual - Page 7
...risk of physical injury after long hours of working in front of a computer. Long work periods, bad posture, poor work habits, stress, inadequate ...display. • Adjust the display brightness and/or contrast to a comfortable level for enhanced text readability
and graphics clarity. • Eliminate glare and reflections by:
• placing your display in such a way that the side faces the window...
User Manual - Page 8
... a piece of cardboard extended from the display's top front edge • Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended periods of time.
Developing good work habits
Develop the following work habits to make your computer use more relaxing and productive...
User Manual - Page 9
...the power cord
4
Power saving
4
Display Data Channel (DDC)
4
Connector pin assignment
5
Standard timing table
8
Installation
9
User controls
10
How to adjust a setting
11
Acer eColor Management
11
Adjusting the OSD settings
12
Adjusting the picture quality
12
Adjusting the OSD setting
13
Adjusting the setting
14
Product information
15
Troubleshooting
16
DVI-DL/HDMI/DP...
User Manual - Page 11
Attaching/removing the base
Installation: By aligning the front-end of the bracket with the corresponding slot on the back of the display, and fix the stand onto the display by screwing the four screws clockwise.
2 1 Remove: Reverse the steps to remove the base.
2
User Manual - Page 13
...-colored power LED.
Model On
Power saving
LED light Blue
Orange
The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the...
User Manual - Page 17
Standard timing table
Mode 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
VGA MAC SVGA SVGA XGA XGA SXGA VESA WXGA WXGA+ WXGA+ WXGA+ UXGA WSXGA+ UXGA WUXGA UXGA WQHD WQHD
Resolution 640×480 640×480 800×600 800×600 1024×768 1024×768 1280×...
User Manual - Page 18
... 24-pin DVI cable to the back of the monitor and the other end to the computer's port. c. Connect the HDMI Cable (Only HDMI-Input Model) (1) Make sure both the monitor and computer are switched off. (2) Connect one end of the 19-pin HDMI cable to the back of the monitor and the other end to the computer's port. d. Connect the digital cable (only...