Acer XF290C driver and firmware
Related Acer XF290C Manual Pages
Download the free PDF manual for Acer XF290C and other Acer manuals at ManualOwl.com
User Manual - Page 4
...power from the equipment, be sure to unplug the power cord from the electrical outlet.
Safe listening
To protect your hearing, follow these instructions.
• Gradually increase the volume until you can hear it clearly and comfortably
and without distortion.
• After setting...in installation unless ...devices.
Using electrical power
• This product should be operated from the type of power...
User Manual - Page 9
...reflections by: • placing your display in such a way that the side faces the window or
any light source
• ...display's top front edge
• Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended
periods of time.
Developing good work habits
Develop the following work habits to make your computer...
User Manual - Page 12
... Communications Commission Declaration of Conformity Unpacking Attaching/removing the base Screen position adjustment Connecting the power cord Power saving Display Data Channel (DDC) Connector pin assignment Standard timing table Installation User controls How to adjust a setting Acer eColor Management User Troubleshooting +'0, mode DVI mode DP mode
1
iii iii iii iii iii iv iv iv iv v vi vi vii...
User Manual - Page 14
English
2
ATTACHING/REMOVING THE BASE
Install: Align the base with the stand and push the base towards the top of the monitor, and then rotate the base clockwise. Tighten the screw clockwise.
Remove: Reverse the steps to remove the base.
User Manual - Page 17
...-colored power LED.
Mode On
Power saving
LED light Blue
Amber
The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the...
User Manual - Page 22
...'s port.
Connect HDMI Cable (Only for HDMI-Input Model)(Optional) a. Make sure both the monitor and computer are powered-OFF. b. Connect the HDMI cable to computer. Or connect MHL cable Or connect MHL cable(Only for MHL-Input Model)(Optional) to the portable device
2 Connect the power cord Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Optional:Connect the audio...
User Manual - Page 24
FreeSync (DP only):
It can allow a FreeSync supported graphics source to dynamically adjust display refresh rate based on typical content frame rates for power efficient, virtually stutter free and low-latency display update.
9
User Manual - Page 27
...
10. Super Sharpness:Turn the sharpness On or Off. Sharpness technology can simulate high-resolution images by boosting the pixel density of the original source to make images sharper and clearer...Use the ◄/► keys to select the setting.
4. Gamma mode allows you to adjust the luminance tone.The default value is 2.2 (standard value for Windows).
5. Color temperature: Default is warm. You ...
User Manual - Page 29
..., or Extreme.
7. HDMI Black level setting
8. Wide mode: You can select which screen aspect you are using. The options are Aspect and 1:1.
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows monitor controls to be sent via software.
10. Quick...