Dell PowerVault 660F driver and firmware
Related Dell PowerVault 660F Manual Pages
Download the free PDF manual for Dell PowerVault 660F and other Dell manuals at ManualOwl.com
Upgrade Installation Guide - Page 5
Dell™ PowerVault™ Fibre Disk RAID Controller Upgrade Installation Guide
Dell PowerVault Fibre Disk RAID Controller for the PowerVault 660F and 224F storage systems provides protection against drive failures and supports configurations using multiple hosts and redundant controllers for improved fault-tolerance and highperformance data throughput.
This document describes the major ...
Upgrade Installation Guide - Page 6
...RAID.
• Supports supports mixed hard-disk drive capacity and revolutions-per-minute
(RPM).
Other Documents You May Need
Besides this guide, the following documentation will be useful in installing and using the controller.
• Dell PowerVault 660F and 224F Storage Systems Installation and Troubleshooting
Guide
• Dell OpenManage Array Manager User's Guide
NOTE: Documentation updates...
Upgrade Installation Guide - Page 7
... and RAID 5 configurations • A Fibre Channel host bus adapter (HBA); use only the Qlogic QLA2200 Fibre
Channel HBA, or later Dell-supported HBA, with the controller
NOTE: If you are installing a dual-active configuration, both controllers must have the same physical configuration, the same amount of memory, and the same firmware version and type.
support.dell.com
Upgrade Installation Guide...
Upgrade Installation Guide - Page 8
... steps to install the Dell Fibre Disk RAID Controller.
NOTICE: This product is to be used with the PowerVault 660F or a PowerVault 224F that has been upgraded to a PowerVault 660F. See the Dell PowerVault 660F and 224 Storage Systems Installation and Troubleshooting Guide for additional installation and safety instructions.
See the manufacturer's installation instructions to install the HBA...
Upgrade Installation Guide - Page 9
4. Tighten the two captive screws on the back of the controller. 5. Connect the drive and host channels according to your planned configuration. For detailed information about installing and using the Dell OpenManage Array Manager, see your Dell OpenManage Array Manager User's Guide or go to http://support.dell.com/docs/software/marb/. The system normally takes a few minutes to boot...
Upgrade Installation Guide - Page 11
...
Length
11.8 in.
Width
4.25 in.
Height
1.1 in.
Power Requirements
Power requirement
5.1 V +/- 5% @ 2.5 A average
Battery charging
12 V +/- 25% @ 0.3
Controller operating limits
5 V +/- 5%
Environment Specifications
Operating temperature
10 ° C to 35° C
Connectors
Backplane
60-pin
Host
one DB 9
Expansion
one HSSDC
support.dell.com
Upgrade Installation Guide 1-7