Dell Vostro 5470 driver and firmware
Related Dell Vostro 5470 Manual Pages
Download the free PDF manual for Dell Vostro 5470 and other Dell manuals at ManualOwl.com
Owners Manual - Page 2
...™ are trademarks of Advanced Micro Devices, Inc. Microsoft®, Windows®, MS-DOS®, Windows Vista®, the Windows Vista start button, and Office Outlook®...players. The Bluetooth® word mark is a registered trademark and owned by the Bluetooth® SIG, Inc. and any use of such mark by Dell Inc. is under license. Wi-Fi® is a registered trademark of Wireless Ethernet...
Owners Manual - Page 3
...20 Installing the Memory...20 Removing the System Board...20 Installing the System Board...23 Removing the Speakers...23 Installing the Speakers...25 Removing the Display Assembly...25 Installing the Display Assembly...27 Removing the Display Bezel...27 Installing the Display Bezel...30 Removing the Display Panel...30 Installing the Display Panel...31 Removing the Camera...31 Installing the Camera...
Owners Manual - Page 4
3 System Setup...33
System Setup Overview...33 Boot Sequence...33 Navigation Keys...33 Updating the BIOS ...34 System Setup Options...34
4 Troubleshooting...37
Enhanced Pre-Boot System Assessment (ePSA) Diagnostics 37 Battery Status Lights...37 Device Status Lights...38 Beep Codes...38
5 Specifications...39
Technical Specification...39
6 Contacting Dell...45
Contacting Dell...45
Owners Manual - Page 5
... Off Your Computer).
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device. 3. Disconnect all network cables from the computer. 4. Disconnect your computer and all attached devices from their electrical outlets. 5. Press and hold the power button while the computer is unplugged to ground the system board. 6. Remove the...
Owners Manual - Page 6
... system, press and hold the power button for about 4 seconds to turn them off.
After Working Inside Your Computer
After you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turning on your computer.
1. Replace the cover.
CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the...
Owners Manual - Page 7
...install the components from your computer.
Recommended Tools
The procedures in this document may require the following tools: • Small flat-blade screwdriver • Phillips screwdriver • Small plastic scribe
System Overview
The figure below displays... the inside view of the back of the computer after the base cover has been removed...
Owners Manual - Page 10
... the screws to secure the base cover to the computer. 3. Follow the procedures in After Working Inside Your Computer.
Removing the Battery
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the base cover. 3. Disconnect the battery cable from its connector on the system board.
4. Release the tabs that secure the battery in the...
Owners Manual - Page 12
... it clicks into place. 2. Connect the battery cable to its connector on the system board. 3. Install the base cover. 4. Follow the procedures in After Working Inside Your Computer.
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) base cover b) battery 3. Lift the hard drive assembly in an upward direction to release it...
Owners Manual - Page 13
... Drive
1. Place the hard drive assembly into its slot on the computer. 2. Install:
a) battery b) base cover 3. Follow the procedures in After Working Inside Your Computer.
Removing the Coin-Cell Battery
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove :
a) base cover b) battery 3. Perform the steps as shown in the illustration: a) Disconnect the coin-cell battery cable...
Owners Manual - Page 14
... b) battery 3. Perform the steps as shown in the illustration: a) Disconnect the antenna cable from the WLAN card. b) Remove the screw that secures the WLAN card to the computer. c) Remove the WLAN card from its slot on the system board.
Installing the WLAN Card
1. Insert the WLAN card into its connector at a 45-degree angle. 2. Tighten the screw to secure...
Owners Manual - Page 15
... SSD card to the computer. 3. Install:
a) battery b) base cover 4. Follow the procedures in After Working Inside Your Computer.
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) base cover b) battery 3. Perform the steps as shown in the illustration: a) Disconnect the left system fan cable from its connector on the system board. b) Remove...
Owners Manual - Page 18
... that secure the left system fan to the system board. 6. Connect the left system fan cable to its connector on the system board. 7. Install :
a) battery b) base cover 8. Follow the procedures in After Working Inside Your Computer.
Removing the Heatsink
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) base cover b) battery c) system fan 3. Remove the...
Owners Manual - Page 20
...memory module into the memory socket. 2. Press the memory module down until it clicks into place. 3. Install:
a) battery b) base cover 4. Follow the procedures in After Working Inside Your Computer.
Removing the System Board
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove:
a) base cover b) battery c) system fan d) heatsink e) hard drive 3. Disconnect the following cables...
Owners Manual - Page 23
... chassis. 2. Tighten the screws to secure the system board to the chassis. 3. Connect the following cable:
a) finger printer b) WLAN c) coin-cell battery d) camera e) touchpad f) keyboard g) display h) speaker 4. Install: a) hard drive b) heatsink c) system fan d) battery e) base cover 5. Follow the procedures in After Working Inside Your Computer.
Removing the Speakers
1. Follow the procedures in...
Owners Manual - Page 25
... board. 4. Install:
a) system board b) heatsink c) system fan d) coin-cell battery e) mSATA SSD card f) WLAN card g) hard drive h) battery i) base cover 5. Follow the procedures in After Working Inside Your Computer.
Removing the Display Assembly
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove :
a) base cover b) battery 3. Disconnect the LVDS cable and the camera cable...
Owners Manual - Page 27
... Assembly
1. Align the base panel of the computer to the display hinges. 2. Install the screws that secure the display hinges to the system board. 3. Connect the LVDS cable and the camera cable to the connectors on the system board. 4. Install :
a) battery b) base cover 5. Follow the procedures in After Working Inside Your Computer.
Removing the Display Bezel
1. Follow the procedures in Before...
Owners Manual - Page 30
Installing the Display Bezel
1. Align the display bezel by pressing along the edges. 2. Install the screws that secure the display bezel. 3. Install the plastic caps that secure the display bezel screws on both sides of the display. 4. Install :
a) battery b) base cover c) display assembly 5. Follow the procedures in After Working Inside Your Computer.
Removing the Display Panel
1. Follow the ...
Owners Manual - Page 31
... that secure the display. 3. Install:
a) battery b) base cover c) display assembly d) display bezel 4. Follow the procedures in After Working Inside Your Computer.
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer. 2. Remove :
a) base cover b) battery c) display assembly d) display bezel e) display 3. Disconnect the camera cable and lift the camera to remove it...
Owners Manual - Page 32
Installing the Camera
1. Align the camera to the base panel . 2. Connect the camera cable to the camera. 3. Install :
a) battery b) base cover c) display assembly d) display bezel e) display 4. Follow the procedures in After Working Inside Your Computer.
32
Owners Manual - Page 34
... and restarts the system. Displays the System Setup help file.
Updating the BIOS
It is recommended to update your BIOS (system setup), on replacing the system board or if an update is available. For laptops, ensure that your computer battery is fully charged and connected to a power outlet
1. Restart the computer. 2. Go to dell.com/support. 3. If you have your computer's Service Tag or Express...