Gigabyte GA-965P-DS3P driver and firmware
Drivers and firmware downloads for this Gigabyte item
Related Gigabyte GA-965P-DS3P Manual Pages
Download the free PDF manual for Gigabyte GA-965P-DS3P and other Gigabyte manuals at ManualOwl.com
Manual - Page 5
... 3-3 Driver CD Information 52 3-4 Hardware Information 53 3-5 Contact Us ...53
Chapter 4 Appendix 55 4-1 Unique Software Utilities 55
4-1-1 EasyTune 5 Introduction 55 4-1-2 Xpress Recovery2 Introduction 56 4-1-3 Flash BIOS Method Introduction 58 4-1-4 Configuring SATA Hard Drive(s 65
A. Intel® ICH8R Southbridge 65 B. GIGABYTE SATA2 Controller 76 4-1-5 2- / 4- / 6- / 8- Channel Audio...
Manual - Page 12
... form factor; 30.5cm x 24.4cm
(Note 1) Applies only when the GA-965P-DS3P motherboard (rev. 3.3) is installed with a 1333 MHz FSB processor. The system will automatically adjust BIOS to support 1333 MHz FSB by overclocking when a 1333 MHz FSB processor is installed. In such a configuration, the actual operating memory frequency will be 667 MHz or 833 MHz, depending on the...
Manual - Page 17
... card. 6. Replace your computer's chassis cover. 7. Power on the computer, if necessary, configure required settings for the expansion card in system
BIOS Setup. 8. Install related driver in the operating system.
For example: Installing a PCI Express x16 VGA card:
To install the VGA card: Please align the VGA card with the PCI Express x16 slot and press down on the card. Make sure the VGA card...
Manual - Page 18
...USB interface. Also
make sure your OS supports USB controller. If your OS does not support USB controller, please
contact OS vendor for possible patch or driver upgrade. For more information please contact your OS or device(s) vendors. LAN Port The provided Internet connection is Gigabit Ethernet.... Devices like CD-ROM, walkman etc. can be connected to Line In jack.
GA-965P-DS3P Motherboard
- 18 -
Manual - Page 25
... LINE2_L FSENSE2
10
AC'97 Audio: Pin No. Definition
1
MIC
2
GND
3
MIC Power
4
NC
5
Line Out (R)
6
NC
7
NC
8
No Pin
9
Line Out (L)
10
NC
By default, the audio driver is configured to support HD Audio. To connect an AC97 front panel audio module to this connector, please refer to the instructions on page 92 about the software settings.
- 25 -
Hardware Installation
Manual - Page 31
... during the BIOS POST (Power-On Self Test) will take you to the CMOS SETUP screen. You can enter the BIOS setup screen by pressing "Ctrl + F1". If you wish to upgrade to a new BIOS, either Gigabyte's Q-Flash or @BIOS utility can be used. Q-Flash allows the user to quickly and easily update or backup BIOS without entering the operating system. @BIOS is a Windows-based...
Manual - Page 51
... you can install others application.
For USB 2.0 driver support under Windows XP operating system, please use Windows Service Pack. After install Windows Service Pack, it will show a question mark "?" in "Universal Serial Bus controller" under "Device Manager". Please remove the question mark and restart the system (System will auto-detect the right USB2.0 driver).
- 51 -
Drivers Installation
Manual - Page 52
English
3-2 Software Applications
This page displays all the tools that Gigabyte developed and some free software, you can choose anyone you want and press "install" to install them.
3-3 Driver CD Information
This page lists the contents of software and drivers in this CD-title.
GA-965P-DS3P Motherboard
- 52 -
Manual - Page 56
... bytes of system memory 3. VESA-supported VGA cards
How to use the Xpress Recovery2 Initial access by booting from CD-ROM and subsequent access by pressing the F9 key: Steps: After entering BIOS Setup, go to Advanced BIOS Feature and set to boot from CD-ROM. Save
the settings and exit the BIOS Setup. Insert the provided driver CD into your CD-ROM drive. Upon system...
Manual - Page 57
... hard disks installed with Windows operating systems including DOS and Windows XP/2000/NT/9x/Me. 5. USB hard disks are currently not supported. 6. Does not support RAID/AHCI (class code 0104/0106) hard disks. 7. Capable of backing up and restoring only the first physical hard disk. Hard disks detection sequence is as follows: a. PATA IDE primary channel b. PATA IDE secondary channel c . SATA IDE...
Manual - Page 60
... F8 key in BIOS Setup. However, if the BIOS update file is saved to a hard drive in RAID/AHCI mode or a hard drive attached to an independent IDE/SATA controller, use the End key during POST to access Q-Flash.
Award Modular BIOS v6.00PG, An Energy Star Ally Copyright (C) 1984-2007, Award Software, Inc.
Intel P965 BIOS for 965P-DS3P F4a . . . .
:BIOS Setup/Dual BIOS : Xpress Recovery2 : Boot...
Manual - Page 63
... a DOS startup disk, we recommend that you use the new @BIOS utility. @BIOS allows users to update their BIOS under Windows. Just select the desired @BIOS server to download the latest version of BIOS.
Fig 1. Installing the @BIOS utility
Fig 2. Installation Complete and Run @BIOS
Click Sart/ Programs/ GIGABYTE/@BIOS
Select @BIOS item than click Install
Fig 3. The @BIOS Utility
Fig 4. Select...
Manual - Page 65
... user's manual to identify the SATA controller for the connectors. (For example, on the GA-965P-DS3P motherboard, the SATAII0, SATAII1, SATAII2, SATAII3, SATAII4 and SATAII5 connectors are supported by the ICH8R southbridge.) Then connect the power connector from your power supply to the hard drive.
(Note 1) Skip this step if you do not want to create RAID array on the SATA controller. (Note...
Manual - Page 72
... for AHCI and RAID Mode)
To install operating system onto a serial ATA hard disk successfully, you need to install the SATA controller driver during OS installation. Without the driver, the hard disk may not be recognized during the Windows setup process. First of all, copy the driver for the SATA controller from the motherboard driver CD-ROM to a floppy disk. See the instructions below about how...
Manual - Page 73
... the floppy disk containing the SATA driver and press S (Figure 15).
Windows Setup
Setup could not determine the type of one or more mass storage devices installed in your system, or you have chosen to manually specify an adapter. Currently, Setup will load support for the following mass storage devices(s)
* To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use...
Manual - Page 74
...have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER.
S=Specify Additional Device ENTER=Continue F3=Exit
Figure 17
(Note) If you set the SATA RAID/AHCI Mode item in BIOS Setup to AHCI mode, please select Intel(R) ICH8R/DO/DH SATA AHCI Controller (Desktop ICH8R).
GA-965P-DS3P Motherboard...
Manual - Page 75
... have installed the SATA controller driver successfully. You can proceed with the Windows 2000/XP installation.
WindowsXP Professional Setup
Welcome to Setup. This port of the Setup program prepares Microsoft(R) Windows (R) XP to run on your computer.
To set up Windows XP now, press ENTER.
To repair a Windows XP installation using Recovery Console, press R.
To quit Setup without installing Windows...
Manual - Page 77
... Windows installation CD-ROM disk, set First Boot Device under the Advanced BIOS Features menu to CDROM (Figure 2).
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software Advanced BIOS Features
Hard Disk Boot Priority First Boot Device Second Boot Device Third Boot Device Password Check HDD S.M.A.R.T. Capability CPU Hyper-Threading Limit CPUID Max. to 3 No-Execute Memory Protect CPU Enhanced...
Manual - Page 84
... for AHCI and RAID Mode)
To install operating system onto a serial ATA hard disk successfully, you need to install the SATA controller driver during OS installation. Without the driver, the hard disk may not be recognized during the Windows setup process. First of all, copy the driver for the SATA controller from the motherboard driver CD-ROM to a floppy disk. See the instructions below about how...
Manual - Page 88
... Settings: We recommend that you use the speaker with amplifier to acquire the best sound effect if the stereo output is applied.
STEP 1 : After installation of the audio driver, you should find an Audio Manager icon in your system tray (you can also find the icon in Control Panel). Doubleclick the icon to open the Audio Control Panel.
GA-965P-DS3P Motherboard...