Sony KV-1221R driver and firmware
Related Sony KV-1221R Manual Pages
Download the free PDF manual for Sony KV-1221R and other Sony manuals at ManualOwl.com
Warranty Card - Page 1
..., to any authorized Sony service facility.
This warranty does not cover customer instruction, installation, set up adjustments or signal...questions:
To locate the servicer or dealer nearest you, or for service assistance or resolution of a service problem, or for product information or operation, call:
Sony Customer Information Services Center 1-800-222-7669
or visit the Sony Web Site: www.sony...
Primary User Manual - Page 3
...set is equipped with a polarized AC power cord plug (one blade of the plug is wider than the other), which will fit into the power...8226; Do not install the set in a location ...the cabinet, unplug the set and have it checked by...set is not to be used for
several days. • Unplug the set...set. For maximum protection, repack your set as it was originally packed at the factory. • To keep the set...
Primary User Manual - Page 11
REMOTE CONTROL OPERATION
Battery installation The Sony Remote Commander RM-702 operates on two AA batteries (supplied). To install batteries into the Commander, proceed as follows: 0 Press and slide to open the battery compartment lid.
Close the lid.
e Install... a year. When the battery is exhausted, the Remote Commander will not operate the TV properly. In this case, replace the batteries with ...
Primary User Manual - Page 17
... position to be included, refer to page 20. • To use your TV set with a cable television system, contact a representative of the cable company for instructions regarding channel selection. In most cases, this adjustment will be made by the cable
company at the time of installation.
0 TO ARRANGE THE ACTIVE VHF AND UHF CHANNELS IN NUMERICAL SEQUENCE OR...
Primary User Manual - Page 18
...memory on the depressed Channelselect Button, and to position its tuning to a frequency below channel 2. Then use the TUNING-up Button to locate your desired station. Note: To skip an unused position during remote control... operation, press the Channel-select Button to be skipped and then the CHANNEL CLEAR Button. (The CHANNEL CLEAR Button only works while the CHANNEL SET Switch is set...