Vantec UGT-PC341 - SuperSpeed USB 3.0 PCIe Host Card driver and firmware
Related Vantec UGT-PC341 Manual Pages
Download the free PDF manual for Vantec UGT-PC341 and other Vantec manuals at ManualOwl.com
Flyer - Page 1
... Rates Up to 480 Mbps w/USB 2.0 4-Pin Molex (Includes SATA Power Converter) 120 x 81 x 19mm
System Requirement
Microsoft Windows XP, Vista & 7 (32/64bit) PCI Express Enabled System w/ Available PCI Express Slot CD-Rom Drive May Be Needed For Drivers
Package Contents
4-Port SuperSpeed USB 3.0 PCIe Host Card x1, User's Manual x1, SATA to 4-Pin Molex Power Converter x1, Driver CD x1
Send us an...
User Guide - Page 2
Contents:
Chapter 1: Introduction 3 1.1 Product Introduction 3 1.2 Features 4 1.3 System Requirements 5 1.4 Package Contents 5
Chapter 2: Getting Started 5 2.1 Hardware Installation 5 2.2 Driver Installation 6 2.3 Hardware Verify 8 2.4 Driver Uninstall 9
Chapter 3: Troubleshooting Tips 10
UGT-PC341
Page 2
User Guide - Page 4
... with Intel's eXtensible Host Controller Interface (xHCI) Specification Revision 0.96 Supports 4 downstream ports for all speeds Built-in 4-pin power connector for receiving extra power supply from system Hot-swapping feature allows you to connect/disconnect devices without powering down the system Support Windows® XP/Vista/7 (32/64 bit)
UGT-PC341
Page 4
User Guide - Page 5
... Manual 1 x SATA to 4 pin Molex Power Converter Note: Contents may vary depending on country/market.
Chapter 2: Getting Started
2.1 Hardware Installation
1. Turn off the power to your computer. 2. Unplug the power cord and remove your computer's cover. 3. Remove the slot bracket from an available PCIe slot. 4. To install the card, carefully align the card's bus connector with
UGT-PC341...
User Guide - Page 6
... PCIe slot on the motherboard. Push the board down firmly. 5. Replace the slot bracket's holding screw to secure the card. 6. Replace the computer cover and reconnect the power cord.
2.2 Driver Installation
1. Insert the provided CD into your disk drive. 2. At the Windows desktop click Start, then Run. 3. Type D:\UGT-PC341\Setup.exe, then click OK. (Change D: to
match your CD-ROM drive letter...
User Guide - Page 7
5. Select "VIA XHCI Host Controller Driver" and press "Next". Please review settings before install the driver, and click "Next" to continue.
6. Click "Next" to continue. Click "Finish" to end of the driver installations steps.
UGT-PC341
Page 7
User Guide - Page 8
7. After driver installation is complete, your must restart your computer.
Note: We do not provide USB 3.0 driver for Mac and Linux OSs.
2.3 Hardware Verify
1. Click on the "Device Manager" tab in the Windows Control Panel. Start > Control Panel > Device Manager
UGT-PC341
Page 8
User Guide - Page 9
2. Entry "Universal Serial Bus controllers" item, and you can read "VIA USB 2.0 Hub", "VIA USB 3.0 Root Hub" and "VIA USB eXtensible Host Controller" in the Device Manager.
2.4 Driver Uninstall
1. Click on the "Programs and Features" tab in the Windows Control Panel. Start > Control Panel > Programs and Features
UGT-PC341
Page 9
User Guide - Page 10
2. Entry "Uninstall or change a program" page, and double click "VIA Platform Device Manager" to process driver uninstallation procedure.
Chapter 3: Troubleshooting Tips
If card and devices connected to the computer do not seem to be working properly, please perform below basic troubleshooting
UGT-PC341
Page 10
User Guide - Page 11
... the PCI Express slot correctly. Please clean golden figure by rubber firstly, then change another PCI Express slot. How to deal with there is a yellow exclamation point on
controller?
1. Please shutdown your computer and move the card to another available slot then re-install USB 3.0 driver.
2. Please point on this device then right-click on the mouse.
UGT-PC341
Page...
User Guide - Page 12
... not enough power can be given to the connected device. Make sure to plug 4-pin power cable on board to provide efficient power to USB devices. But the better way is using device self-power to satisfy it. Is it possible to connect current USB 1.1 or 2.0 devices to the USB 3.0 PCI Express card? Yes it works. Device will not obtain the USB 3.0 speed, but USB 2.0/1.1.
UGT-PC341
Page 12