Acer EB210HQ driver and firmware
Related Acer EB210HQ Manual Pages
Download the free PDF manual for Acer EB210HQ and other Acer manuals at ManualOwl.com
User Manual - Page 4
... fuse rating.
• Do not overload a power outlet, strip or receptacle by plugging in too many devices. The overall system load must not exceed 80% of the branch circuit rating. If power strips are used, the load should not exceed 80% of the power strip's input rating.
• This product's power cord is equipped with a three-wire...
User Manual - Page 7
...risk of physical injury after long hours of working in front of a computer. Long work periods, bad posture, poor work habits, stress, inadequate ...display. • Adjust the display brightness and/or contrast to a comfortable level for enhanced text readability
and graphics clarity. • Eliminate glare and reflections by:
• placing your display in such a way that the side faces the window...
User Manual - Page 8
... a piece of cardboard extended from the display's top front edge • Avoid adjusting your display to an awkward viewing angle. • Avoid looking at bright light sources, such as open windows, for extended periods of time.
Developing good work habits
Develop the following work habits to make your computer use more relaxing and productive...
User Manual - Page 9
...the power cord
3
Power saving
3
Display Data Channel (DDC)
3
Connector pin assignment
4
Standard timing table
6
Installation
7
User controls
8
How to adjust a setting
9
Acer eColor Management
9
Adjusting the OSD settings
10
Adjusting the picture quality
10
Adjusting the OSD setting
11
Adjusting the setting
12
Product information
13
Troubleshooting
14
VGA mode
14
DVI...
User Manual - Page 11
Attaching/removing the base
Installation: Place the stand onto the display by aligning the screw holes on them, and fix the stand onto the display by screwing the four screws clockwise.
Remove: Reverse the steps to remove the base.
2
User Manual - Page 12
...-colored power LED.
Model On
Power saving
LED light Blue
Orange
The power saving mode will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3 seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the...
User Manual - Page 15
Standard timing table
Mode 1 2 3 4 5 6 7 8 9 10 11 12 13 14
VGA MAC VESA SVGA SVGA XGA XGA VESA SXGA VESA WXGA WXGA+ WXGA+ UXGA
Resolution 640×480 640×480 720×400 800×600 800×600 1024×768 1024×768 1152×864 1280&#...
User Manual - Page 16
... and computer are switched off. b. Connect the VGA video cable to the computer. c. Connect the digital cable (only for dual-input models). (1) Make sure both the monitor and computer are switched off. (2) Connect one end of the 24-pin DVI cable to the back of the monitor and the other end to the computer's port.
2. Connect the power cord Connect the power cord...