Biostar P4TDK driver and firmware
Related Biostar P4TDK Manual Pages
Download the free PDF manual for Biostar P4TDK and other Biostar manuals at ManualOwl.com
P4TDK user's manual - Page 1
...digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions...'s manual. All the brand and product names are trademarks of their respective companies.
i
P4TDK user's manual - Page 3
...), 1394 Chip (optional). Contains on board I/O facilities, which include two serial port, a parallel port, a PS/2 mouse port, a PS/2 keyboard port, audio ports, USB ports, a LAN port (optional) and a game port. Supports the Intel Pentium 4® (Socket 478) processor up to 2.4 GHz. Supports Ultra 100/66/33, BMIDE and PIO modes. Supports USB2.0 High Speed Device. Supports up to 2 GB for 4 single...
P4TDK user's manual - Page 5
... the white dot or cut edge in the CPU. Match Pin A with the white dot/cut edge then insert the CPU.
3. Press the lever down. Then Put the fan on the CPU and buckle it and put the fan's power port into the JCFAN1, then to complete the installation.
CPU/ System Fan Headers: JCFAN1/ JSFAN1
12V Ground...
P4TDK user's manual - Page 9
... DDeessccrriippttiioonn
Front Panel Connector: JPANEL1
12
SLP
SPK
SPK
==> Speaker Conn.
HLED ==> Hard Driver LED
HLED
PWR_LED RST
==> Reset Button
IR
==> Infrared Conn.
RST
ON/OFF SLP
==> Sleep Button
PWR_LED ==> Power LED
ON/ OFF ==> Power-on Button
IR
IR
23 24
Memory Stick Header: JMS1 (optional)
1
JMS1
Pin1 ==> Ground , Pin2 ==> MS1 Pin3 ==> 3.3V , Pin4...
P4TDK user's manual - Page 19
... the
power indicator lights are lit, hard drive is DIMM, press down firmly until the module
spinning.
snaps into place.
PROBABLE
SOLUTION
System does not boot from hard disk drive, can * Check cable running from disk to disk
be booted from CD-ROM drive.
controller board. Make sure both ends are
securely plugged in; check the drive type in
the standard CMOS setup...