HP Indigo 5000 - Digital Press driver and firmware
Drivers and firmware downloads for this Hewlett-Packard item
Related HP Indigo 5000 Manual Pages
Download the free PDF manual for HP Indigo 5000 and other HP manuals at ManualOwl.com
HP DesignJet 5000 Series Printer - Setup Poster - Page 1
Setup Instructions
HP DesignJet 5000PS & HP DesignJet 5000
HP DesignJet Printer 60 inch (1.57 m)
st501
HP DesignJet Printer 42 inch (1.07 m)
st501a
Read these instructions carefully...
What You Will Need For This Procedure:
n Because some of the components of the printer are bulky, you may need two or three people to lift them. When this is necessary this symbol is displayed:
The Take...
HP DesignJet 5000 Series Printer - Setup Poster - Page 2
... Remove the main printer box.
st509
Remove...the outside of the Cross Brace.
st512
Install eight screws into the Legs as shown ...
3. Installing the legs onto the printer
Printer Handles
st502
Find the handles on the rear of the printer as...covering and put the legs assembly on the Printer as shown and secure with four screws.
...printer onto the boxes. Note: The boxes must have the polystyrene inside to...
HP DesignJet 5000 Series Printer - Setup Poster - Page 3
... the Packing Tape and the Desiccant Bag.
st528
Remove the protective covering from the Printer Window.
st529
Open the window and remove the Carriage Packing Material.
5. Install the Take-Up Reel Assembly
st569
Install the Pocket on the rear of the printer.
Install the Take-Up Reel as shown in the following steps.
st530
Loosen the four...
HP DesignJet 5000 Series Printer - Setup Poster - Page 4
... spindle.
3 inch core adaptors
st591
If you want to use a 3 inch (76mm) cardboard core instead of the plastic core supplied, adaptors are available with your printer.
Page 4
st593
Install the adapters on to the media guides as shown. Note: These are for use with a 3 inch (76mm) cardboard core only.
HP DesignJet 5000 Series Printer - Setup Poster - Page 5
... this way
st547
Install the left and right deflectors on top of the printer's cross brace.
st548
Slide deflector supports sideways until the T-piece on top of the support is fully inserted into...supports with the two screws provided.
st543
Connect the power cord into the rear of the take-up reel.
Turn on the take-up reel by turning the switch to On at the rear.
7. Bin Assembly installation (HP...
HP DesignJet 5000 Series Printer - Setup Poster - Page 6
...
st587
Install the right adapter to the right leg at the rear as shown above. The right hand adapter is marked with the letter 'R'.
st588
Install the left hand adapter to ...Install the extensions onto the media deflectors.
2 1
st557
Plug the power cord into the socket next to the power switch, and then into the AC power outlet.
2 1
st558
Turn the power isolator switch at the rear of the printer...
HP DesignJet 5000 Series Printer - Setup Poster - Page 7
... slots.
INK CART. ACCESS HP ink cartridges successfully installed
Press ENTER to continue
When all SIX ink cartridges have been installed correctly, the front panel will display the above.
INK STARTUP Initializing printer Please wait xx sec
Press ENTER. The front panel displays the above.
INK STARTUP Lift window to replace SETUP printheads
When the printer has primed the ink system...
HP DesignJet 5000 Series Printer - Setup Poster - Page 8
...service station, close the door.
INK STARTUP Checking printhead CLEANERS
The front panel displays the above.
The printer will now start the printhead test.
If it is successful, the front panel will instruct you to load the media; then the printer will run the printhead alignment check.
11. Installing... orientation of the paper is loaded exactly as shown. The blue media guide must be on the left....
HP DesignJet 5000 Series Printer - Setup Poster - Page 9
..., lower the media load lever.
st039a
Lower the window of the printer.
If you have a Take-Up Reel installed, the front panel will display the above. Using the up and down keys, select 'No'. For information on loading the Take-Up Reel, refer to the Pocket Guide or the User's Reference Guide.
The front panel displays the above.
Select...
HP DesignJet 5000 Series Printer - Setup Poster - Page 10
... next page and perform the procedures for setting up your printer on the network and installing the software.
To obtain useful information before setting up your printer on the network:
n Go to the Setup menu in the printer's front panel. n Select I/O Setup and press Enter. n Select Card ID and press Enter.
Write down the hardware and IP addresses: (ETHER=xxxxxxxxxxxx and IP=nnn.nnn.nnn...
HP DesignJet 5000 Series Printer - Setup Poster - Page 12
... When you get to the Network Printer Setup screen, select Novell Server Setup.
If you have Internet access, you can also get the software from HP's Web Site, the HP Download Service, Compuserve or AOL. You will find more through the driver software installation instructions, and a description of all supported installation methods on our web site,
www.hp.com/go/designjet. For detailed information...