Asus P2-PH1 driver and firmware
Related Asus P2-PH1 Manual Pages
Download the free PDF manual for Asus P2-PH1 and other Asus manuals at ManualOwl.com
Instruction Manual - Page 1
English
P-Series
ASUS PC (Desktop Barebone)
Installation manual
Download the latest manual from the ASUS website: www.asus.com
Instruction Manual - Page 2
...) 6. Power LED ( ) 7. Front panel cover 8. Reset button ( )
• VGA port ( ) • HDMI port ( )
• Parallel port (
)
• USB 2.0 ports ( )
9.* • MS/MS Pro card slot ( )
• LAN (RJ-45) port ( )
• CF card slot ( ) • SD/MMC card slot ( )
• Serial (COM1) port ( )
• DVI-D port (
)
• MS/MS Pro/SD/MMC card slot ( ) • Optical S/PDIF...
Instruction Manual - Page 3
English
Internal components
3
2
1
4
5
7
6
1. Front panel cover 2. 5.25-inch optical drive and
3.5-inch hard disk drive cage 3. Power supply unit
4. PCI card riser bracket (connected to the motherboard PCI slot)
5. ASUS motherboard* 6. DIMM sockets 7. CPU fan
NOTE: *Refer to the system User Guide for motherboard details.
Removing the cover
1. Remove the cover screws on the rear panel. ...
Instruction Manual - Page 4
...
1. Lay the system on its side, then
locate and remove three storage
2
drive assembly screws.
2. Lift the storage drive assembly, then
set aside.
1
1
1
Removing the CPU fan and heatsink assembly
Removing an Intel® CPU fan and heatsink assembly
1. Disconnect the CPU fan cable from the connector on the motherboard.
2. Loosen the four screws out of the fan holes to...
Instruction Manual - Page 5
... socket lever to secure the CPU.
1
2
3
NOTE: To reinstall an Intel® / AMD CPU fan and heatsink assembly, follow the instructions on page 4 in reverse order.
CAUTION: After you reinstall a fan and heatsink assembly, do not forget to connect the CPU fan connector! Hardware monitoring error can occur if you fail to plug this connector.
Installation manual
Instruction Manual - Page 6
... PCI riser card assembly to 2. Remove the metal cover opposite
remove.
the slot that you intend to use.
3. Insert the card connector to the
slot, then press the card firmly until it fits in place. Secure the card with a screw.
4. Reinstall the PCI riser card assembly. Make sure that the riser card connector sits properly on the motherboard PCI slot.
Installation manual
Instruction Manual - Page 7
... drive assembly
1. Connect the IDE (1A) and power (1B) plugs to connectors at the back of the optical drive.
2. Connect the SATA/IDE (2A) and power (2B) plugs to the connectors at the back of the SATA/IDE hard disk drives.
3. Install the storage drive assembly to the chassis. 4. Secure the storage drive assembly with three screws.
SATA
IDE
1B 1A
3
R
2B 2A
2B
2A
R
4
Installation manual...
Instruction Manual - Page 8
Installing the foot stand
1. Insert the foot stand hooks into
2.
the holes on the chassis.
Pull the foot stand to the ...removed earlier.
NOTE: Refer to the pictures in the section "Removing the cover" on page 3 in reverse order.
NOTE: For P2 model, if your optical drive tray fails to eject when you press the eject button, attach the provided sticker to the location shown at the back of the...