D-Link DFE-530TX driver and firmware
Drivers and firmware downloads for this D-Link item
Related D-Link DFE-530TX Manual Pages
Download the free PDF manual for D-Link DFE-530TX and other D-Link manuals at ManualOwl.com
Product Manual - Page 2
.... This warranty applies to purchased software, and to replacement software provided by D-Link pursuant to this warranty, but shall not apply to any update or replacement which may be provided for download via the Internet, or to any update which may otherwise be provided free of charge.
D-Link's sole obligation under this software warranty shall be to replace any...
Product Manual - Page 3
...PCI Fast Ethernet Adapter Card
Warranty Period
For warranty in your region, please check with your local D-Link office and authorized agents as warranty periods may vary from region to region. The warranty for power supplies and power adapters is one year.
LIMITATION OF WARRANTIES
IF THE D-LINK... WITH THE SALE, INSTALLATION MAINTENANCE OR USE OF D-LINK'S PRODUCTS. D-LINK SHALL NOT BE LIABLE...
Product Manual - Page 5
10/100 PCI Fast Ethernet Adapter Card
Table of Contents
FAST ETHERNET ...5 AUTO-NEGOTIATION ...5 FEATURES...5 UNPACKING AND INSPECTION...6 INSTALLING THE ADAPTER ...6 CONNECTING THE NETWORK CABLE ...6
Connecting for Fast Ethernet (100Mbps)...6 Connecting for 10Mbps Ethernet...7 Using a Crossover Cable...7 SOFTWARE INSTALLATION...7
4
Product Manual - Page 6
..., the DFE-530TX Adapter provides the following features: • 32-bit PCI Bus Master memory access for high throughput. • PCI clock speed up to 33Mhz, independent of network clock. • ACPI 1.1 power management compliant. • Complies with IEEE 802.3 100Base-TX and 10Base-T Ethernet standards. • Plug and Play installation. • RJ-45 connector for network cable connection...
Product Manual - Page 7
...DFE-530TX card into any available PCI Bus expansion slot.
4. Install the bracket screw to secure the card to the computer chassis.
5. Replace the computer cover.
6. Reconnect the computer power cord, and switch computer power on. If the BIOS section of your computer boot program is Plug and Play compliant, then at power-up the BIOS will automatically configure any newly installed DFE-530TX adapter...
Product Manual - Page 8
.../100 PCI Fast Ethernet Adapter Card
plug at each end. Make the network connection by plugging one end of the cable into the RJ-45 jack of the DFE-530TX, and the other end into a port of the supporting hub.
Connecting for 10Mbps Ethernet
Category 3, Category 4, and Category 5 UTP cable, as well as EIA/TIA-568 100-ohm STP cable, all qualify under Ethernet cabling...
Product Manual - Page 9
... manually by a CMOS Setup utility run after you have reinstalled all of the expansion cards.
The DFE-530TX Adapter features two LED indicators to assist in the resolving of network diagnostics: • LINK/ACT Indicator
A steady green LED indicates that the card is receiving power and there is a good link between the DFE-530TX and the device it is connected to. The LED will flash...
Product Manual - Page 10
... for 100Mbps baseband CSMA/CD local area network • Ethernet 10BASE-T
IEEE 802.3 standard for 10Mbps baseband CSMA/CD local area network Jumperless Hardware Auto-negotiation functionality Media interface: RJ-45 EMI Compatibility:
FCC Class B/VCCI Class B/CE Class B C-Tick/BSMI Class B
Host interface: PCI 2.2 Bus (Bus Master)
I/O & IRQ base address: Assigned by Plug and Play system...
Product Manual - Page 13
Registration Card
Print, type or use block letters.
Your name: Mr./Ms Organization Dept Your title at organization Telephone Fax Organization's full address Country Date of purchase (Month/Day/Year
Product Model
Product Serial No.
* Product installed in type of computer (e.g., Compaq 486)
* Product installed Computer serial No.
(* Applies to adapters only)
Product was purchased ...