Dell PowerVault MD3000 driver and firmware
Related Dell PowerVault MD3000 Manual Pages
Download the free PDF manual for Dell PowerVault MD3000 and other Dell manuals at ManualOwl.com
View - Page 5
...-plug, 3.0-Gbps, serial-attached SCSI (SAS) and/or Serial Advanced
Technology Attachment II(SATA II) physical disks • SAS 5/E adapter for connecting the storage array to the server(s)
NOTE: System boot is not supported from an external device attached to a SAS or SCSI adapter, including SAS 5/E, PERC 5/E, PERC 4e/DC, or PERC 4/DC. See support.dell.com for the latest support information about...
View - Page 6
...'s Manual. Dell Enterprise Training and Certification is available; see www.dell.com/training for more information. This service may not be offered in all locations.
Installation and Configuration
CAUTION: Before performing the following procedure, read and follow the safety instructions and important regulatory information in your Product Information Guide. This section describes the steps to set...
View - Page 7
... shipping materials in case you need them later.
Installing the Rails and System in a Rack
Once you have read the "Safety Instructions" located in the rack installation documentation for your system, install the rails and the system in the rack.
See your rack installation documentation for instructions on installing your system in a rack.
Getting Started With Your...
View - Page 9
Turning on the System
Power on the system by turning on both power supply/cooling fan modules.
Installing the Bezel
Install the bezel (optional) by inserting the right edge of the bezel into the right front loop on the system, and then pressing the left edge of the bezel to the system until the bezel snaps into place.
Getting Started With Your System
7
View - Page 10
...Debug connector (per RAID controller)
1 6-pin mini-DIN connector (debug port for Dell factory use only)
Ethernet connector (per RAID controller)
1 10/100 BASE-T connection for out-of-band management of the enclosure
Backplane Board
Connectors
• 15 SAS physical-disk connectors • 2 power supply/cooling fan module connectors • 2 sets of RAID controller connectors (6 connectors...
View - Page 11
RAID controllers
The following single-color LEDs: • Battery fault • Cache active • Controller fault • Controller power • Ethernet link • Ethernet activity • SAS Out fault • SAS Out active • SAS In fault (2 if additional In connector installed) • SAS In active (2 if additional In connector installed)
Power supply/cooling fan module
3 ...