Brother International HL 760 - B/W Laser Printer driver and firmware
Drivers and firmware downloads for this Brother International item
Related Brother International HL 760 Manual Pages
Download the free PDF manual for Brother International HL 760 and other Brother International manuals at ManualOwl.com
Quick Setup Guide - English - Page 10
English: HL-YL Quick Setup Guide, Body
Action 6-1: Prepare Windows 95 for the Printer
You need to configure Windows 95 for the printer by installing the printer driver and TrueType™-compatible fonts from the supplied disk into Windows 95. 1. Make sure that your printer is connected to your computer. 2. Turn on your printer. 3. Turn on your computer
and start Windows 95. The screen shown on ...
Quick Setup Guide - English - Page 11
English: HL-YL Quick Setup Guide, Body
Action 6-2: Prepare Windows 3.1 for the Printer
You need to configure Windows 3.1 for the printer by installing the printer driver and TrueType-compatible fonts from the supplied disk into Windows 3.1. Since the supplied printer driver and fonts are compressed on the disk, be sure to use the supplied installer program to install them. These instructions ...
Quick Setup Guide - English - Page 12
English: HL-YL Quick Setup Guide, Body
Action 6-3: Prepare DOS for the Printer
How to Use the Printer in Your DOS Application Software (without using the Windows system) Before working with application software that runs under DOS, if you do not already have a suitable driver installed, you will need to install a printer driver that matches one of the following supported emulations: HP LaserJet ...
Quick Setup Guide - English - Page 13
English: HL-YL Quick Setup Guide, Body
Installing the Remote Printer Console
Before you install the program, make sure that you have the following hardware and software:
DOS Monitor Option
Version 3.3 or later EGA/VGA or compatible Mouse; the mouse driver must be installed. (You can also operate the program with the keyboard.)
Follow these steps to install the remote printer console program:...
Quick Setup Guide - English - Page 15
... System software version 6.0.7 or above to use this printer driver. This printer driver only supports the 300 dpi mode when used with a Macintosh computer. When setting up the printer to work with your Macintosh computer, you will need to use the RS-422A serial interface. The serial interface board is an option. For information on options, consult your dealer or refer to the User's Guide...
Users Manual - English - Page 3
Laser Printer HL-760 Series User's Guide
...downloading drivers from our Bulletin Board Service, call:
In USA
1-714-859-2610
In CANADA
1-514-685-2040
Please log on to our BBS with your first name, last name and a four digit number for
your password. Our BBS supports modem speeds up to 14,400, 8 bits, no parity, 1
stop bit.
Fax-Back System (For USA only) Brother Customer Service has installed...
Users Manual - English - Page 15
... Windows system using our installer program. The driver supports our unique compression mode to enhance printing speed in Windows applications and allows you to choose various printer settings including toner saving mode, custom paper size, sleep mode, gray scale adjustment, resolution and so forth. You can easily set these print options through the Printer Setup Menu within the Windows Control...
Users Manual - English - Page 16
... status or errors on your computer screen.
t Popular Printer Emulation Support This printer supports three popular printer emulation modes, HP LaserJet 5P, Epson FX-850, and IBM Proprinter XL. When you use DOS application software or Windows version 3.0 or earlier, you can use any of these emulations to operate the printer in the 300 dpi resolution mode. The printer also supports auto-emulation...
Users Manual - English - Page 17
... printer's standard memory.
t Environment-Friendly Economy Printing Mode This feature will cut your printing cost by saving toner. It is useful to obtain draft copies for proof-reading. You can select from two economy modes-25% toner saving and 50% toner saving-through the Windows printer driver supplied with your printer. Sleep Mode (Power Save Mode) When the printer...
Users Manual - English - Page 36
...the factory settings. • Set the RS-232C parameters to match your computer. You can set serial settings in several different places, within your DOS application, within the Windows Printer Icon (for Windows application software only), or within your AUTOEXEC.BAT file using MODE commands. For information on serial interface parameters, see the user's guide of your computer or software.
CHAPTER...
Users Manual - English - Page 40
... following specifications:
Speed
60 nsec - 80 nsec
Pin Type 72 pin
Height
35.00 mm (1.38") or less
Output32 bit or 36 bit
Note This printer can also support DIB graphics with a resolution of 1200 x 600 dpi under Windows 95/Windows 3.1 with the supplied printer driver. We recommend to expand the printer memory to avoid any memory full error.
CHAPTER 4 -6
Users Manual - English - Page 60
...reduce the print resolution.
• Expand the printer memory by installing SIMM and set page
protection to ON by using the supplied Windows driver or
RPC program.
Parallel Interface Line • Press the panel switch to resume printing.
Error
• Check that the connection between your computer and printer is
secure and correct, and check the interface cable.
Serial Interface Framing...
Users Manual - English - Page 66
... cooling down to lower the printers internal temperature. Open the top cover until the temperature reduces.
Setting Up the Printer for Windows
Question I cannot print from my application software.
Sometimes I get a Print Overrun error when printing certain documents from Windows.
Recommendation • Make sure the supplied Windows printer driver is
installed and selected with your application...
Users Manual - English - Page 67
... following settings on the driver and try again.
Page Protection
Graphics Mode TrueType™ Mode Use Printer TrueType™ Fonts • Add more memory by installing an industry standard SIMM. • Reduce the print resolution or reduce the complexity of your document and try again.
Setting Up the Printer for DOS
Question I cannot print from my application software.
The printer prints...
Users Manual - English - Page 68
USER'S GUIDE
Setting Up the Printer for Apple Macintosh Computers when the Optional RS-100M Serial Interface is Installed into Your Printer
Question I cannot print from my application software.
Recommendation
• Make sure that the supplied Macintosh printer driver is installed in the System Folder and it is selected with Chooser.
• Check the PORT selection within the Chooser: it ...
Users Manual - English - Page 69
... a problem usually relating to serial interface settings. Your computer is not recognizing the printer's input buffer full signal. Causes could be incorrect serial cable (incorrectly wired or too long) or incorrect setting of your computer serial interface. Some applications download several types and sizes of fonts. This can use up your printer memory very quickly. Set the Page Protection to AUTO...
Users Manual - English - Page 74
...IBM Proprinter XL
Printer Driver
Windows 3.1/3.11 and Windows 95 driver, supporting Brother Native Compression mode and bi-directional capability
Optional Macintosh driver available for System 6.0.7 or higher
TrueType Fonts on disks TrueType-compatible soft-fonts for Windows on the supplied disk
Interface
Bi-directional parallel (IEEE 1284 compliant) RS-422A/RS-232C serial interface (RS-100M...
Email Printing Users Manual - English - Page 2
...AUTOMATIC E-MAIL PRINTING 5
1. INSTALL WITH THE SUPPLIED DISK...5 2. INSTALL WITH THE FILE DOWNLOADED FROM BROTHER HOME PAGE 8
CHAPTER 4 DELETE AUTOMATIC E-MAIL PRINTING 9
CHAPTER 5 USING AUTOMATIC E-MAIL PRINTING 10
1. AFTER INSTALLATION IS COMPLETED 10 2. USER REGISTRATION...10 3. MAIN WINDOW ...11 4. PROPERTIES...12 5. SERVER ...13 6. CHECK ...14 7. PAGE SETUP...15 8. PRINT ...16 9. FILTER...
Email Printing Users Manual - English - Page 7
... AUTOMATIC E-MAIL PRINTING
1. INSTALL WITH THE SUPPLIED DISK Install the Automatic E-Mail Printing software with the disk supplied with the printer. (1) Insert the floppy disk labeled 'Automatic E-Mail Printing for Microsoft Windows 95, Printer driver
disk for Microsoft Windows NT 4.0' into the drive A (or B) of your computer. (2) Click Start, then select Run. (3) Type A:\SETUP and press the Enter...
Email Printing Users Manual - English - Page 25
...) You can use it in Microsoft Windows NT 4.0 Service Pack 2 Intel processor version, or higher, under the LAN environment. However, the software is designed for Windows 95/98. If you use it in Windows NT, consult your PC administrator.
Q3) Can I use the software with the 16 bit TCP/IP driver?
A3) No. The software requires the 32 bit TCP/IP...