Dell PowerEdge 840 driver and firmware
Related Dell PowerEdge 840 Manual Pages
Download the free PDF manual for Dell PowerEdge 840 and other Dell manuals at ManualOwl.com
Information Update - Dell OpenManage™ Server Support Kit Version 4.3
(.pdf) - Page 3
.... b Configure the DRAC 4/P as explained in the Dell Remote Access Controller 4 User's Guide. c Exit the DRAC 4/P setup program. The system then continues its boot. If you are running a Microsoft® Windows® operating system, the operating system detects several new DRAC 4/P-related devices as it starts. The drivers for those devices are located in one of the following paths...
Information Update - Dell OpenManage™ Server Support Kit Version 4.3
(.pdf) - Page 7
www.dell.com | support.dell.com
图 2. DRAC 4/P 视频和 NIC
卡 NIC 连接器
10 配置 DRAC 4/P 卡： a DRAC 4/P
Information Update - Dell OpenManage™ Server Support Kit Version 4.3
(.pdf) - Page 20
... Management Dell: Remote Access Controller - DRAC 4/P (Driver) Windows 2003 DRAC4 Drivers (Self Extracting Zip) または Dell: Remote Access Controller - DRAC 4/P (Driver) Windows 2000 DRAC4 Drivers (Self Extracting Zip Zip Windows DRAC 4/P Novell® NetWare Red Hat® Linux
2004 Dell Inc Printed in the U.S.A. Dell Inc Dell、DELL PowerEdge は Dell...
Information Update - Dell OpenManage™ Server Support Kit Version 4.3
(.pdf) - Page 23
www.dell.com | support.dell.com
그림 2. DRAC 4/P NIC
카드 NIC 커넥터
10 DRAC 4/P a DRAC 4/P
Getting Started Guide - Page 5
... PCI-X (3.3-V) slots
• An integrated Gigabit Ethernet NIC, capable of supporting 10-Mbps, 100-Mbps, or 1000-Mbps data rates, with support for IPMI 1.5 and Wake-on-LAN.
• Four USB 2.0-compliant connectors (two on the front and two on the back) capable of supporting a diskette drive, CD-ROM drive, keyboard, mouse, or USB flash drive.
• An integrated ATI ES1000 SVGA video controller...
Getting Started Guide - Page 6
...internal, 1-inch, Serial-Attached SCSI (SAS) hard drives with an optional SAS
controller card or backplane.
NOTE: Hot-plug capability is supported only when SATA or SAS drives are connected to the optional SAS controller card or backplane.
• Optional remote access controller (DRAC 4) for remote systems management. This option requires a dedicated PCI slot.
• One 420-W power supply. For...
Getting Started Guide - Page 7
... for any components you purchased separately provides information necessary to configure and install these options.
• Updates are sometimes included with the system to describe changes to the system, software, and/or documentation.
NOTE: Always check for updates on support.dell.com and read the updates first because they often supersede information in other documents.
• Release...
Getting Started Guide - Page 10
... the monitor's controls until the displayed image is satisfactory.
Complete the 0perating System Setup
If you purchased a preinstalled operating system, see the operating system documentation that ships with your system. To install an operating system for the first time, see the Quick Installation Guide. Be sure the operating system is installed before installing hardware or software not purchased...
Hardware Owner's Manual (PDF) - Page 9
...; The Getting Started Guide provides an overview of system features, setting up your system, and technical specifications.
• CDs included with your system provide documentation and tools for configuring and managing your system.
• Systems management software documentation describes the features, requirements, installation, and basic operation of the software.
• Operating system...
Hardware Owner's Manual (PDF) - Page 10
... documentation for your RAID card.
Option is displayed only if you have PXE support enabled through the System Setup Program (see "Integrated Devices Screen" on page 34). This keystroke allows you to configure NIC settings for PXE boot. For more information, see the documentation for your integrated NIC.
If you have the optional Dell Remote Access Controller (DRAC), this keystroke...
Hardware Owner's Manual (PDF) - Page 14
... a specific connector and device drivers must be installed before the device operates properly. (Device drivers are normally included with your operating system software or with the device itself.) See the documentation that accompanied the device for specific installation and configuration instructions.
• Always attach an external device while your system and the device are turned off. Next...
Hardware Owner's Manual (PDF) - Page 17
Hard-Drive Indicator Codes
If an optional SAS backplane is installed in the system, two indicators on each of the hard-drive carriers provide information on the status of the hard drives. See Figure 1-4 and Table 1-5. The SAS backplane firmware controls the drive power-on/fault indicator. Figure 1-4. Hard-Drive Indicators
1
2
1 drive status indicator
2 drive busy indicator
About Your System
17
Hardware Owner's Manual (PDF) - Page 19
...System Memory" on page 100.
Diskette drive 0 seek failure
Incorrect configuration settings in Run the System Setup program to
System Setup program.
correct the settings. See "Using the
System Setup Program" on page 29.
Faulty or improperly installed diskette, loose diskette drive or optical drive interface cable, or loose power cable.
Replace the diskette. Ensure that the diskette drive and...
Hardware Owner's Manual (PDF) - Page 25
... boot hard drive.
with your system.
Warning! No microcode update loaded for processor n
Unsupported processor.
Update the BIOS firmware using the Dell Support website at support.dell.com.
Write fault
Write fault on selected drive
Faulty diskette, diskette drive, optical drive, hard drive.
Replace the diskette. Ensure that the diskette drive, optical drive, and harddrive cables are properly...
Hardware Owner's Manual (PDF) - Page 103
... test. See "Using Dell PowerEdge Diagnostics" on page 111. 4 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 5 Open the system. See "Opening the System" on page 43. 6 Ensure that the interface cable is securely connected to the optical drive and to the controller. 7 Ensure that a power cable is properly connected to...
Hardware Owner's Manual (PDF) - Page 104
... information about safety precautions, working inside the computer and protecting against electrostatic discharge. 7 Ensure that the SCSI controller card is firmly seated in its connector. See "Installing an Expansion Card" on page 72. 8 Ensure that the tape drive's data and power cables are properly connected to the tape drive and SCSI controller card. 9 Close the system. See "Closing the System...
Hardware Owner's Manual (PDF) - Page 150
... RAID.
mm - Millimeter(s).
ms - Millisecond(s). MS-DOS® - Microsoft Disk Operating System.
NAS - Network Attached Storage. NAS is one of the concepts used for implementing shared storage on a network. NAS systems have their own operating systems, integrated hardware, and software that are optimized to serve specific storage needs.
NIC - Network interface controller. A device that is installed...
Hardware Owner's Manual (PDF) - Page 151
... as RAM and hard drives.
processor - The primary computational chip inside the system that controls the interpretation and execution of arithmetic and logic functions. Software written for one processor must usually be revised to run on another processor. CPU is a synonym for processor.
protected mode - An operating mode that allows operating systems to implement: • A memory address space...
Hardware Owner's Manual (PDF) - Page 152
ROMB - RAID on motherboard.
rpm - Revolutions per minute.
RTC - Real-time clock.
SAS - Serial-attached SCSI.
SATA - Serial Advanced Technology Attachment. A standard interface between the system board and storage devices.
SCSI - Small computer system interface. An I/O bus interface with faster data transmission rates than standard ports.
SDRAM - Synchronous dynamic random-access memory.
sec - ...
Hardware Owner's Manual (PDF) - Page 153
... automatically supplies power to your system in the event of an electrical failure.
USB - Universal Serial Bus. A USB connector provides a single connection point for multiple USB-compliant devices, such as mice and keyboards. USB devices can be connected and disconnected while the system is running.
utility - A program used to manage system resources- memory, disk drives, or printers, for example...